cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
570
Views
0
Helpful
1
Replies

UNTESTED output for admin diagnostic start location 0/0/CPU0 test all-test

sourabh2
Cisco Employee
Cisco Employee

Hello,

 

I am getting below output with U keyword i.e. Untested

 

what is the meaning of this?  Is this kind of HW failure of testing?

 

please advise.

 

 

 

Test results: (. = Pass, F = Fail, U = Untested)

 

  ___________________________________________________________________________

 

  1  ) SrspStandbyEobcHeartbeat --------> U

 

          Error code ------------------> 0 (DIAG_SUCCESS)

          Total run count -------------> 0

          Last test execution time ----> n/a

          First test failure time -----> n/a

          Last test failure time ------> n/a

          Last test pass time ---------> n/a

          Total failure count ---------> 0

          Consecutive failure count ---> 0

  ___________________________________________________________________________

 

  2  ) SrspActiveEobcHeartbeat ---------> U

 

          Error code ------------------> 0 (DIAG_SUCCESS)

          Total run count -------------> 0

          Last test execution time ----> n/a

          First test failure time -----> n/a

          Last test failure time ------> n/a

          Last test pass time ---------> n/a

          Total failure count ---------> 0

          Consecutive failure count ---> 0

1 Reply 1

mivens
Level 1
Level 1
SRSP tests are only run on the standby RP/RSP, not LCs. Are you sure you're not looking at the output of "show diagnostic result" for the active RSP or RP? The command "diagnostic start location 0/0/CPU0 test all-test" produces no ouput when I try it (asr9k/xr 6.5.3).
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: