10-25-2012 01:22 AM
Hi
I have some questions about VRF configuration on IOS-XR 4.1.
I'm trying to configure BGP routing with vrf and I get the
following error when trying to commit my config:
===================================================
address-family ipv4 unicast
!!% 'BGP' detected the 'warning' condition 'The parent address family
has not been initialized'
===================================================
However, It is solved by configure "address-family vpnv4 unicast"
before committing the vrfs.
But, I'm not sure about that above configure are best practice or not.
Q1. Do you have a best practice configuration of BGP with VRF?
or
Q2. I have to use "address-family vpnv4 unicast" on IOS-XR ?
Please advice me.
Best regards,
Kim
Solved! Go to Solution.
11-07-2012 09:05 PM
Hi Kim ,
you must configure "address-family vpnv4 unicast" on BGP globally so you will be able to commit the configuration for the address-family.
You can refer the below link to understand how MPLS L3VPN's are configured on IOS-Xr.
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.5/mpls/configuration/guide/gc35v3.html#wp1026378
11-07-2012 09:05 PM
Hi Kim ,
you must configure "address-family vpnv4 unicast" on BGP globally so you will be able to commit the configuration for the address-family.
You can refer the below link to understand how MPLS L3VPN's are configured on IOS-Xr.
http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.5/mpls/configuration/guide/gc35v3.html#wp1026378
11-11-2012 11:18 PM
Hi Kumar
Thank you for your support.
Best regards
Kim
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide