Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Hi All,I am looking to configure static entries in the sticky table for ip A.B.C.D going to "serverZ". From what I know, the connections coming in from A.B.C.D will always first go to serverZ. If serverZ fails then new connections coming in from the ...

Has anyone else experienced this?  I have a remote site setup using a WAAS 574 in inline mode (connected to a 2811 router) and whenever I enable the CIFS Accelerator on the device (and the Central Office WAAS) the remote site end users start gaining ...

plato9888 by Level 1
  • 868 Views
  • 1 replies
  • 0 Helpful votes

I just wondered if I could please ask a question I have in regards SNAT on the ACE modules that someone might have encountered elsewhere.Scenrio is currently the CSS load balancers we use in one enviroment are being consolidated into a ACE module.Cur...

achrich by Level 1
  • 2137 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Weak ciphers

I want to disallow https requests to content VIPS with weak ciphers. This is for PCI DSS compliance. I'm thinking I can use a parameter map. But I haven't though it all through. Has anyone done similar that can share a config example? If so much appr...

jwitkow11 by Level 1
  • 3994 Views
  • 4 replies
  • 0 Helpful votes

I need to update the cipher on my ssl parameter map and I need to know once I make the change on the parameter map does that change take effect when I hit enter or do I need to do something else to activate the change.I'm going to change my cipher li...

shday by Level 1
  • 774 Views
  • 3 replies
  • 0 Helpful votes

Hi,Is it possible to upgrade ACE 4710 from A3 to A4? What does this actualy means by A3, A4 & A5.I want to upgrade ACE from A3 to A4 becase I want to enable switch-mode on ACE.  Current S/W version is A3 2.0 which is not supporting this command.  Whi...

I am currently on version 4.2.3b  of WAAS software and would like to upgrade to the current 4.4.3c. Can I upgrade directly to the latest or do I need to step up to a particular version before proceeding to the latest?Any help with this would be great...