Application Networking

Dear Community!We have recently installed an ACE 4710 appliance in our network:- HA cluster- each of our 3 contexts operating in active mode at primary site- software version A3(2.4)- L3 routed modeThere is a HTTPS reverse proxy configured in ACE and...

Hi,What all the parameters can be used for stickiness across different data centers via CiscoGSS. Is cookie stickiness possible.We are planning to implement an Active/Active site and theinternet user requests will be load balanced across two sites. S...

As we know, a WEB2.0 business is consist of more services, and those services communicte with each other.If one service shutdown, and failover to another DataCenter, other services must talk with it cross datacenter, that will reduce the whole system...

What is the best way to handle the Admin context in an HA environment if it is only being used for management?  Do you allocate it to a failover group or leave it out?Thanks!

hi everyoneI enable SSL optimized function and it work finebut I have a questionin my environment, most SSL tcp session size is under 10 KBso when small size tcp session optimized by waasit's optimized bytes is bigger than original byteso, does waas ...

Hi all,i need to deploy WAE with inline card towards two routers. as i understand, i need to use each group ports (lan 0 & wan 0, lan 1 & wan 1) to each router.i am using the wae as a vlan mapping, ingress vlan 700 egress vlan 701 (interface vlan on ...

Hi,Is there anyone know when CSM will support IPv6?Regards,Yoesa

We currently use the ACE module to Load-balancing IPSEC connection into SPA's.  Since the SPA's only support 60 new connections per second.  I was looking for a way to limit the amount of connecitons from the ACE to the SPA's.

Hi all,We are testing an 574 with inlinecard togeter with ASA version 8.Here is the flow "Router <-> WAE <-> ASA <-> Switch" is this right or should we have it between the switch and the ASA?We have enabled inspect WAAS in the ASA, anything else that...

I have a VIP that terminates ssl connections, andthe real servers are http on port 8080. There are three separate appsinvolved, example is site/inspector, site/reporter, and site/admin.I do not have logins for the separate apps, but all three are rea...