Application Networking

Hi,I wanna ask if WAAS deployment could cause duplicate mails received by users on remote sites. I just deploy WAAS 4.1 using hub and spoke topology with CORE using WAE-7341-K9 and the other sites (suffering duplicate mails) using WAVE-474-K9. So far...

Hi Experts,I have CSS and it was working fine before. For testing purpose I added another CSS for redundancy after which CSS stopped doing load balancing.Hence I have removed the backup CSS and have only one CSS which is active but still  CSS is not ...

Hi Experts,     We deployed WAAS in our network as described in the attached diagram, each datacentre  WAE's have wccp neighbourship with adjacent DC router only . It was working  fine with single tunnel to datacentre and almost all traffics were opt...

Hi All,We have 6509 switch with FWSM (Bridged) and CSM in two different buildings, say site-A is Primary and site-B is DR.  These two 6500 switch are configured with HSRP to decide primary. I can reach DR switch, FWSM and CSM but unable to reach the ...

Hi,I am getting and error ont eh WAE as per the attachements. How can I get rid of this error.I have the setup where the WAE at one end is behing a PIX 7.0 and the VPNs between the branches over the internet are terminated on routers. I configured th...

Hi.When I enter the show conn  in ace active module, I had got the following log.--------------------------------------------------------------------------------40335      1  in  TCP   162  aaa.bbb.ccc.ddd:53974  eee.fff.ggg.hhh:1433  CLOSED41091    ...

Hi all,can a css 11503 balance on services that are not directly connected but are on remote routed lan?!Thanks

I have a customer who wants to restrict outbound from CSS to certian sites with certian ports. Basically they want to go to site www.xxx.com on port 2400 and www.yyy.com on port 3500. Thats it. All other traffic should be restricted from CSShow can t...

Hi Experts,I have ACE module in my network running as redundancy. and my issue is  I dont see anything when I run the cmds sh run/log.Could anyone tell me what is causing this to happen? And when I tried to collect the show tech it started a bit then...