Application Networking

Hi,We are configuring ace module for load balancing of two real servers in bridged mode. The real servers are actually virtual machines. Before loadbalancing configuration the physical server was connected to MSFC with actual vlan 47. the virtual ser...

Hello everybody,After my WAE-7341-K9 rebooted, it had a boot problem. At the begin, it showed this menu: Press F1 for Setup Press F2 for Diagnostics Controller started Press F12 to select boot deviceAfter I pressed F12, the WAE booted and run normaly...

In a lab environment I have 1 WAE 612 (4.0) Control Manager and 2 WAE 512 (4.0) with a Transport License.Af first I want upgrade all at 4.1 and go to Transport to Enterprise.First question: for the 612 is it sufficient an upgrade to 4.1 maintaining t...

Hi,I am trying to find in the documentation, but it is being hard to solve, if it is possible to connect simultaneously to more than one Core-WAE from a Edge-WAE

We have deployed ACNS on a WAE-612 for transparent proxy via WCCP. WCCP is active on a 6509 and redirects all outbound HTTP/HTTPS traffic through the WAE. The WAE is also configured as a proxy that will accept proxy connections on port 8080.We have a...

Hello, Can Cisco LMS monitor and report on ACE module probes. Thanks.

v have a 4710 appliance ad want to use it for LBfollowing the current setupfirewall,2950 switch, serversfirewall inside interface is connected to 2950 switch in vlan 100all servers are connected to the same switch in vlan 100. firewall is the default...

In looking into my earlier problem with SSL termination I set up a simple test context to try to reproduce it. I now have a situation where either HTTP or HTTPS access works - but never both. Which protocol works depends on how many times I remove th...

As I understand, the "persistent rebalance" is like KeepAlive. If so, what is the default keepAlive timeout? If someone knows, could you point out the reference/docs?Thx, Q.Xie

I have a customer who wishes to use CSS to front end web servers and have the CSS perform SSL offload- straightforwardHowever the application may need client authentication - ie client certs.The config guide shows that this can be done on the CSS but...

Hi, I would like to know if it is possible to use the NME-WAE-502 or/and the NME-WAE-522 as WAE Core for small networks.Thanks

hi...i have a problem with my waas NME WAE302there is no data traffic in the report.i still can ping and telnet to my waas, please help me what i have to do.

We are going to build a WAAS network, and are going to do HA at each location. I see the config examples talking about load balancing...but is there an HA design guide...