Application Networking

I want to configure 'ip helper-address' on the Server side vlan on ACE Context to forward UDP broadcasts. The L3 interface for the servers are on ACE and the servers want to communicate to the NIS servers by resolving ypbind.I tried the command 'ip d...

HelloI'm trying to configure the SSL client authentication in ACE module. The config looks like thatcrypto authgroup CLI_AUTHENTICATIONcert CAssl-proxy service SSL-testauthgroup CLI_AUTHENTICATIONcert cert.pemkey key.pemThe config works ok, without t...

HelloI'm trying to configure the stickiness based on the cookies on the ACE module. Stickiness seems to work, but unfortunately when I'm checking the show sticky database there are no entries. I've tried to test the active cookie method but I observe...

I want to deploy WAAS between a head office and a DR site, they will either connect through a private WAN or the Internet. A requirement is for the traffic to be encrypted and as such IPSEC VTIs will be used to enable routing as there will also be a ...

Hi all,I´ve search for this error but not found it anywhere.This is ssh related.Could u help me please ?<em>SSHD-0: Read from socket failed: errno = 0x36</em>Best Regards,Bruno Petronio

Hello,in one of our contexts we have a sync problem on the standby unit."sh ft group detail" gives"Running cfg sync status : Error on Standby device when applying configuration file replicated from active", while "Startup cfg sync status" is OK. "sh ...

Hi allI've just got my hands on my first Cisco ACE and I'm trying to configure it with two contexts (Admin+Web) in a simple 1 arm mode.I can successfully reach the management ip x.x.0.16 (VLAN 1000 in the Admin context), but I cannot ping the ip (y.y...

I'm running oe574-4.1.3.55 on a WAE574, I've created Standby Group 1 but when I tried to map the virtual-blade to the NIC it failed with following error:GigabitEthernet 1/0 is part of an Standby group. To use this interface in a virtual blade, it mus...

MTB-WAE-522#sh statis connection!!O-ST: Origin State, T-ST: Terminal StateE: Established, S: Syn, A: Ack, F: Fin, R: Resets: sent, r: received, O: Options, P: PassthroughLocal IP:Port Remote IP:Port Peer ID O-ST T-ST ConnType 68.142.123.126:80 xxx.xx...

Hi AllWe installed a WAAS in a bank environment and configured WCCP to redirect all traffic between the HO and Branch to the WAE devicesEverything worked fine except the AS400 replication between the 2 sites, it is sooooooo slow and when we denied th...

DearssI am trying to configure traffic redirection for WAAS. from one side i have the WAE attached to a layer 2 switch and the default gateway is the router. by doing router on a stick. on the edge side, i have a WAE attched to a layer 3 switch where...