Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

I need to change the URL in the request from https://www.example.com to https://www.example.com/es/example/I have tried several ways,both using location and Host, putting the dot and the slash between brackets [.] [/] with (.*) and %1, but none of th...

juanrin75 by Community Member
  • 1218 Views
  • 3 replies
  • 0 Helpful votes

Team, I have to load balance some servers that communicate via port 443. These servers are configured with a cert and provide the cookie. Do I need to configure a cert and key on the ACE module even though the server will provide the cert? Could some...

jteixido by Level 3
  • 899 Views
  • 4 replies
  • 0 Helpful votes

Greetings:I have an ACE module that is load balancing a pair of AVS 3120 devices. I want to create a probe to monitor the AVS devices to remove them if they fail to perform. Does anyone have a recommendation of the best practice for the probe design?...

kdvorak0 by Community Member
  • 743 Views
  • 2 replies
  • 0 Helpful votes

I just read that the Cisco NAM 4.0 software now supports reading information from the Cisco Flow Agent available in Cisco WAAS 4.0.13 and beyond. How does this feature work exactly? How do NetQOS and NAM speak to the WAAS software and glean informati...

mlouis by Level 5
  • 1234 Views
  • 5 replies
  • 0 Helpful votes

Resolved! WAAS and DFS

I have customer that is looking to use WASAS 4.1.1 to accelerate their existing DFS based infrastructure. Basically, they have file servers located in each branch. These file servers consume about 500-1TB of disk space per server. Mainly large constr...

mlouis by Level 5
  • 1247 Views
  • 2 replies
  • 0 Helpful votes

HiI have a requirement to setup some sort of failover with regards to a web filter server. We have 2 web filters which are setup to load-balance for any http traffic to any web site. However some web sites don' respond well to this and so we have an ...

james_46 by Level 1
  • 859 Views
  • 2 replies
  • 0 Helpful votes

I have an issue with ICMP packets sent to ACE. Our network management tool (Vitalnet) is sending small ICMP packets (paylod of 12 bytes only) and ACE responds in a very strange way. The response to the first packet is correct (only 12 bytes) and Ethe...

admin_2 by Level 7
  • 815 Views
  • 1 replies
  • 0 Helpful votes