Application Networking

I'm using 2X ApplicationServer for Windows Terminal Server. It uses port 81 to connect to the Application server and then RDP 3389 to the Terminal Servers from the Application server. I have added a diagram to review.I have added a policy to Optimize...

Hi to all, I've a problem with CSS keepalives and IBM MQIPT listening on port 1431.I send tcp keepalives with tcp-close rst. It seems that MQIPT register the connection opened by the CSS but don't close the connection when the CSS send the rst. When ...

I have the below ACL on our CSS.A recent port scan from a vulnerability test showed the port for the app session was open.even though the acl is showing clause 55 at the bottom of the list, it still should be in sequence correct?Also is the app sessi...

(1) What source IP address does a CSS (ver 7.5) use for (a) logging, (b) TACACS? Is it always the management port IP address? Can it be specified?(2) What Eth port does a CSS (ver 7.5) use for (a) logging, (b) TACACS? Is it the management or a standa...

Hi,Running on bridge mode, our CSM is seeing the gateway I created for the client as being down when I do the "show mod csm # arp". Below is the config:CSM:vlan 100 client ip address 10.1.1.8 255.255.255.0 gateway 10.1.1.1 vlan 200 server ip address ...

Hi allwhen schedule a report and send it by mail to us we receive a mail with sender [email protected], our customer wants to change thisi have checked the config properties in CM (not CLI) and looked after button of reports but i can't find an op...

I have the CSS and It has not been able to go up the service between servers and CSS. I installed a sniffer and I detected that the CSS are sending duplicated TCP packets.

Hi Guys,A basic question on the GSS. One of our customers would like to upgrade their GSS OS from the CD instead of using FTP. I have looked around on Cisco and could not find any document on that. All documents I have seen are using FTP. Would someo...

Hi, I have replaced the SSL certs with the other ones on ACE module. Still the old Cert pops up while accessing the webpage via SSL proxy on ACE. I removed ssl-proxy from policy-maps. Did 'no key', 'no cert' and then added key, cert to the ssl-proxy ...

I recently deployed ACE 4710 to load balance traffic to a group of web servers. I would like to add additional server farm(s) with different applications on them to ACE 4710 for load balancing the traffic. How can I best achieve this goal? I currentl...

VIP from servers on port 8888 is visible with telnet and the other way around but HTTP://VIP(IP address):8888 is not working for webportal servers,

Hi guys, i got this error message, when i try to log in, on CSS "Telnel Line full".There is some action to take for reset the currunt active sessions? I can't reboot the CSS.Best regardsMaurizio

I have a Networkers 2008 "Deploying WAAS" presentation that discusses an SSL AO. Upon upgrading to version 4.1.1c I notice there is no reference to the SSL AO in the GUI or a way to configure it in the configuration guide. Is this feature available, ...