Application Networking

A las 21.15, River juega el partido ante Atlético Nacional; seguí la previa desde adentroEn VIVO: comienza a llenarse el Monumental y ya se siente el ... At. Nacional ... River Plate.Horario River Plate vs Atlético Nacional Copa Sudamericana 2014 :  ...

I'd like to know if Cisco ACE can be used as reverse proxy specifically for System Center 2012 R2 and also have it filtered to only allow a specific list of non-standard HTTP verbs through.  We would like to see if we can place an ACE device in our D...

I need to format a compact flash for the WAAS.  Can you explain the format and options to format a compact flash for a WAE-674?I tried the method I've use for our router compact flash, but it doesn't recognize the format (insert the flash in a router...

I have the fol  error messages appearede1t1_module-3-lineflap; interface Serial receiving excessive errored packetsWhere is the problem?RegardsAdy

Hi,For a specific implementation, I need the ACE to parse URIs with cyrillic characters in a Layer-7 class-map. Does the ACE-4710 support it ?If yes, how to enter them in a L7 class-map statement like : match http url /Искусство.*Thank you for any hi...

ACE 30 module running A4(2.3) code.  I want to turn off SSLv3 support, but seeing some different behavior when doing so.  Perhaps someone can explain the ACE behavior. When ACE is set to all versions (SSLv3 and TLS1.0), if a TLS1.2 Client Hello is re...

Hello,I have some questions about WAAS (I used the virtual servers and not appliances) :- Why I cannot execute the command "wccp version 2" on a WAE ? Is it by default ?- In mode Inline, do I choose as options WCCP,APP Controller,VPATh or OTHER  ?- T...

Hello, We had upgrade to A5 3.0 and reload device device has lost all its configuration, after that we downgraded to same version as primary A5 1.2 and add back basic config, once we enable FT groups devices going thre sync process and displays below...

HelloI have a configuration in the ACE module to NOT perform NAT with the command transparent in a serverfarm configuration mode, but it is not working. rserver host MXMTYIPR  ip address 172.19.127.131  inserviceserverfarm host _Front  transparent  r...

Hi,Have an WAE 674 with 4.4.3c installed, with problem.Using WCCP and I am able to logon to the device.Have this msg and in in the CM it is down.System Initialization Finished.Disk based software not installed.Some applications may not run correctly!...

Can Anybody tell me, how the ACE is connected physically with the host switch 6500/7600 for data path? Cheers,Deepak