Application Networking

Hi,I wolud like to allow my user only they need to work on rserver thrgh ACSmeans go to reserver -- no in service/in serviceRegards.sateesh

Hi to ALLI Have this situation an css15500 Configured to redirect queries to port 7178 to three servers.The CSS VIP is 192.168.1.55the page on the servers to be opened is http://192.168.1.55:7178/forms/frmservelet?config=test123I need that when clien...

Is there a way to turn of the y/n question while copying services from one CSS to another?

I have a new ACE 4710. I am unable to get the mail server to send mail through the ACE. I have even set the ACL to any any both inside and outside. The mail server worked fine when it was behind the ALTEON load balancer.Don't know what I am missing a...

I have a backend server creating a connection to a db server outside the ACE environment. This traffic is using the L3 function of the ACE and is not being load balanced. The connection is timing out after 1 hour. I have normalization disabled on the...

After upgrading from 4.0.17 to 4.1.1 one of our WAE's has the major error "kernel crash files / or user core files detected. This WAE was also changed from a core device to transparent. size time of last change name -------------- -------------------...

Hi,I have a problem defining a PrimarysorryServer on a ssl content.It cannot function....Below the content configurationcontent WEBFARM-RACDATI-HTTPS vip address 172.20.10.78 vip-ping-response local-remote application ssl sticky-inact-timeout 10 redu...

HiWe are intending to use and ACE appliance to re-direct web traffic to a set of proxy servers. The proxy mechanism is transparent proxy, and there for the clients IP address are not VIPs but real IPs on the internet. I'm unclear on how to set this u...

I have a client that is looking for a load balancer either CSS or ACE. He wants to run his webservers on 8080 for http and 8081 for https, however he wants his users to be able to just go to the url using http or https. I am pretty sure the CSS can d...

Existng setup:SW-Dist1 SW-Dist2 | |SW1 SW2ACE 1 --- ACE2ActiveC1C2C3where C1-3 are contexts, all contexts are active in ACE1.These ACE are modules in 6504 switches.SW1 and SW2 respectively.SW1 and SW2 are trunked to Distribution Switches via port cha...

I have a simple config with a virtual server accepting all ports and pointing to a serverfarm with one server. I can ping the VIP fine and then it stops responding for no reason that I can find. I rebooted the CSMs and upgraded code from 4.2(3a) to 4...

Hi, I have a requirement to use the ACE to provide Active/Standby service for 2 services located on 2 physical servers. Server A is active for one port and backup for antoher, Server B vice versa.As well as this, I am doing port translation - incomin...

Hello,I am trying to setup a class-map using http loadbalance match-all.What I want to do is check for the HTTP Host and if it doesnot match the http referer than go to server farm A. if it does match then go to server farm B.My problem is the host c...

Does the ACE keep audit trail of changes made? I could not find any audit commands where it will tell me what changes were made