Application Networking

I just wondering if anyone had a suggestion as to how best setup a load-balancing environment in DR. Here's a quick rundown.I've got two 11503's, that load-balance numerous servers here internally. Using a 0ne-arm configuration. Would like an active-...

Hi,Can someone tell me what has the NIC teaming effect on WAAS. I was preparing a demo for one of my client but before this they were using another popular WAAS product. According to my client, they had a big network issue with NIC teaming, i.e one i...

Hello,On a ACE module running software version ACE2(1.0), I have defined a virtual smtp server that is load-balanced to a serverfarm containing 2 SMTP servers. Normal SMTP connexions on port 25 work fine. SMTPS connexions to port 465 of a second vser...

Hi!I have an ACE probing a web page hosted in microsoft IIS.IIS has the web pages with integrated authentication. This means that when I try to probe an URL I get status=forbiden. I also tryed with the "credentials" command but the result was the sam...

Hi!The serverfarm contains 2 rserver.We use default round-robin algorithm for load-balance.Our experience ACE send every second connection to same server.2 here 2 there etc.Is it normally ?Regards,

Hi,I have an ACE deployment with 4 contexts. In all the 4 contexts I have configured for Roundrobin load balance with 2 servers and sticky source IP. This works well.But sometimes in one of the context, the Round robin LB not happens to appear. All t...

Trying to do a graceful shutdown on the WAAS box and it's telling me I need su rights. I know I have admin privileges, so I'm not sure what is it looking for. v4.0.19

Hi All,1. Should the GSS need a public IP? Which is recommended?2. The A response is created in GSS. But the Sniffer shows that the GSS is sending the response to the DNS and then DNS forwards it to the browser. Is this the valid behaviour. Or should...

I did a write erase in a new ASA firewall, and now I cannot configure the interface settings like nameif, ip address.Is there a way to roll back to the default configuration.

I have 2 geographically separated sites, site A in the main office and site B is the Disaster recovery office. These 2 sites are connected by a high speed Layer 3 link (10Gb), The goal is to have duplicate servers available in site B in the event of ...

HelloI would like to view detailed statistics for each server-farm like: current transfer, avarage delay etc. I could not find such in CLI. Are they available thru SNMP ? How ?Thanx