Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to go inline for our WAE towards the WAN but our provider Masergy recommends WCCP. Anyone had any problems?Their responce is that with VPLS specifically, since it's with the same broadcast domain…they see problems with the TCP wrapping of BG...
Using a CSS11501 in routed mode and we need the servers to have access to the VIPs for testing.I know we have to NAT the server ip to force the response back through the CSS and I got this working before using:clause 5 permit any <server ip> destinat...
Please correct me if I am off base as I am new to the technology. As a Best Practice, is it suggested that the the compression and encryption that Citrix does by default be turned off in order to receive the most benefit from WAAS and the WAE applian...
Is is possible to use the VRRP-MIB (1.3.6.1.2.1.68) to monitor the (VRRP) redundancy state of a CSS? The CSS Administration Guide only mentiones 1.3.6.1.4.1.9.9.368 (Cisco branch) for this.
I am trying to configure a CSS 11501 to send requests with a specific string in the URL to a specific server. How and where I would specify the string? The documentation, as far as I can tell, mentions that it can be done but does not show how. Any i...
hello all,I need configure something like this: policy STREAM-VOD url-map STREAM-VOD serverfarm STREAM-VOD map STREAM-VOD url match protocol http url */vod/*my question is about url map definition: "*/vod/*". I can't define more specific regexp, beca...
All physical interfaces on ACE 4710 share the same MAC address. Also, VIP addresses share the same MAC address. ACE 4710 is connected to a switch. How is the switch supposed to know which interface to send the packet to if it is doing layer2 switchin...
Server A, Server B, Server C are connected directly to CSS (Network Address 192.168.XX.XX). clients access the servers through Internet and get connected as well as load balanced. But our servers are unable to track the source IP address of the clien...
I want to know mib for monitoring about ace module.example.current real server sessionreal server max sessionreal server total seesionreal server highest sesssioncurrent verser sever seesionvserver max sessionvserver total sessionvserver highest sess...
HiOur WAEs are only connected via internet vpn tunnel and all is good. However, We have observed that when we start data transfer over VPN, its consumed our whole bandwidth (6Mbps) which make other process slower. Can we put some cap at say 4Mbps~5Mb...
Has anyone had success in connecting Canon multi-function printers to a WAAS print queue that is available to clients?I can create the queue and attach to it through a client, but the Windows status constantly states "Access denied, unable to connect...
Been working only on ACE equipment and now I have to solve a mac sticky problem, but on a CSS instead.mac-sticky is enabled on a vlan interface on an ACE in bridged mode, it make sure that all traffic sourced on that interface is destined back throug...
We have two CSS running in box to box redundancy in two-arm (router mode) on code 8.10.40. Master is running with ip redundancy master (causing it to always be master if it is up and running). We had a need to reload a previous configuration. To do t...
we configured http-head keepalives on GSS, but get no positive answer. therefore the question: is there any possibility to check the http-head request manually from the GSS, like on CSS with "icp probe host <ip> "<html site>" <port> thx in advance
