Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Are location-cookies supported on the ACE? Location-cookies are a CSS feature and may be called differently on the ACE but I couldn't find any relevant info on the ACE doc. Thanks in advance for the help,Fabrice
I was looking for a MIB for the CSS and I find multiple MIBs here that begin with ALTIGA..ftp://ftp.cisco.com/pub/mibs/v2/My perl tools writer says he is expecting me to provide a single MIB for the CSS. Why are there multiple MIBs instead of a sing...
We are trying to set up content routing on an SSL flow, and hence need to use both front-end and back-end SSL for the flow. I understand that the service IP and port must correspond to the server ip and port for the backend-server defined in the ssl-...
HiI have a pair of CSS's in active standby configuration loadbalacing HTTPS sessions between two servers. When looking at the dormant flows on the standby box I do not see any entries for the HTTPS sessions. Any clues to why this may be
Hi everyone,There are two parameters in "WAN Utilization settings" on WAFS configuration, "Maximum allocated bandwidth" and "Minimum roundtrip delay".I think those parameters are used to get WAFS throttled traffic over the connection between peer WAF...
Hi All,I am doing load balancing for users accessing an application servers.In basic configuration the application servers see the source IP of the users as the VIP of thier group and not the original client source IP.Is there a way to disable the NA...
I have been given the task of configuring a Cisco ACE20 initially for SLB. I have configured IOS SLB sucesfully but the ACE appears far more complex. Does anyone have any confgiuration guides with diagrams. The Cisco documentation only gives command ...
Hello All,I'm trying to make a lab with the compression feature of the CSS11501S-C-K9, with SW Version 08.10.1.06, but i guess its not working.I've the following design:Client <---> (VIP 10.1.2.199) CSS <---> Switch (Service 10.1.1.199)Network 10....
I have configured my CSS to balance using the Leastconn method but it appears load distribution is still being done disproportionately. The IOS version is 08.10.1.06 and the config in production is as shown below: content Schedules protocol tcp ...
Is it possible to use a WAE appliance (WAE-512-K9) as an inline device without purchasing a WAE-INLN-4CG=? The device has 2 NICS, and I really wouldn't have a need for more than 1 port in and 1 port out.Thanks,Jason
Hi All,I?m currently trying to deploy/test AVS appliances (3120, 3180 v. 6.0). I found useful docs at CCO, DocDVD but I'm at a loss to understand. Can anyone guide me where can I find some more in-depth documentation (case studies, configuration gui...
Hi there,i have a little problem with tacacs+ and the ace module.i have configured aaa authentication with tacacs. The authentication with the ACS works fine. But when i am logged in on the ACE module, i can't work with the command configure... when ...
Hi CSS experts,We have a Cisco Content Services Switch 11503 Load Balancer which seems to require Real Server NICs to be plugged in. When I plug a cable from our Cisco 3560 switch into the Cisco Load Balancer, it can't see the 2 web server IP's tha...
