Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Could someone give me a short answer on the differences betwenn CSM and ACE? For example if you configured an ACE in a DMZ can you still configure VIP with vserver command? Are the configurations similar? I know that the policy configuration is diffe...

clarkmat by Level 1
  • 1142 Views
  • 3 replies
  • 0 Helpful votes

Hello all,I have a strange problem.many remote connection to VIP have timeout. However local connection to VIP works.#sh mod csm 9 stats Connections Created: 69Connections Destroyed: 14Connections Current: 55Connections Timed-Out: ...

edaguet by Level 1
  • 1295 Views
  • 4 replies
  • 0 Helpful votes

I currently have an 11501 series CSS and am trying to have authentication use our ACS appliance. I added the config listed below but when running a "show tacacs-server" both servers are listed as dead. I am able to ping both of the ACS servers with...

Resolved! CSS outbound NAT

I've seen several posts in this forum relating to outbound (source) NAT'ing on a CSS but am still confused as to what I need to accomplish this. I've got four servers behind a CSS that need to be PAT'd to a single public address for outbound access....

mbell by Level 1
  • 1679 Views
  • 8 replies
  • 0 Helpful votes

access-list 30 remark John Doeaccess-list 30 permit 10.3.2.15access-list 30 deny any logsnmp-server community CSS RW 30The above configuration is what we currently have on our routers and switches. Could someone help me convert the above into confi...

Please someone tell me What exactly AON Blade does?In what type of network it is useful?I have gone through some documents saying suitable for Application oriented network.AON acts as policy enforcement point on network. I am not getting these high f...

dshakya by Level 1
  • 926 Views
  • 7 replies
  • 0 Helpful votes

I'm deploying a CSM in bridge mode that will be used in conjunction with a FWSM that acts as the gateway for each server farm. From Cisco's CSM & FWSM design guide they state, "The most important point is that by specifying the incoming VLAN in the ...

triplecap by Level 1
  • 1116 Views
  • 7 replies
  • 0 Helpful votes