Application Networking

Hi All,I did a failover testing with 2 CSS11503 and found a ftp problem.I ftp one file from the server which behind 2 CSS, I tried to force failover happen by shutdown external interface. The ftp transfering was also terminated. How can I keep file s...

Can CSM do Radius Load Balancing? Seems to be no!!!! if no is there a workaround for this?

Hi: I have a CSM with a SSL module. How do I disable the CSM from sending SSL closure alerts to the client?Also is there a way to increase the amount of time the CSM waits before it send the SSL closure alert. Looks like the default is 14 seconds.Tha...

Hiin CSS debug mode:CSS_XXX(debug)# show redundant-intRedundant-Interfaces: Interface Address: 10.0.239.166 VRID: 3 Redundant Address: 10.0.239.167 Range: 1 State: Backup Master IP: 10.0.239.165 State Changes: 2 Last Change: 29/06/2006 00:28:08 arpMa...

Hi,We have a 2811 router with VPN and NAT configured. We have two internet connection from different ISPs. The speed of our original connection is 2MB up and down. The speed of our new connection is 1MB up and down. We want to configure load balancin...

HiI have a CSS11050 running fine with 9 servers in 3 different pools. I use 1 port of the CSS to connect to a switch, and I use the switch to connect the 9 servers. I have plans to connect an addition 2 servers in the same manner. At present the CSS ...

Hi I know the url filtering can be enabled using the CCSC-SSM of the ASA.Does this use a external database for filtering sites

Is there a way to enable both the old XML in the 7.x.x code and CVDM in the 8.x.x code? Stats were eaiser to retrieve in the XML.

HiDoes the Content Engine store the passwords which are used to access various sites in its cache? As I understand the passwords will be cached in an encrypted form. If they are cached then can I remove them from the cache?Thank youRegardsSushil

Hi guys, I have no experience with IOS server load balancing and I need to present a guide to IOS web Server Load Balancing. Are there any documents listing the best practices for IOS load balancing anywhere? I have been looking. It is technology (ap...

IS it possible to activate or suspend services with a snmp set command?Thanks in advance

hi,everyone: I want to config two WAE611 AS my proxy servers,the one is primary and the other one is as backup,so based-config guide(the primary and backup proxy server), i need config like this,http proxy outgoing host 10.1.1.1 8088 primaryhttp prox...

I'm seeing an issue with our CSS 11501 (SW vers 08.10.1.06) units where the per-connection (flow?) throughput is very slow. It appears to be capped around 100kBps. CSS port 1 has an internet uplink on n.n.n.1. The CSS vlan IP is n.n.n.2/27 (via circu...

Hi,I have 4 GSS installed in the network that load balance users to 3 data centers and in each of them I have a CSM module. The KAL-AP protocol is configured between all GSS and all CSM in order to retrieve the load value form each site. On the GSSM ...