Application Networking

Can we place content engine outside interface on PIX DMZ interface. At this moment both the WCCP router and content Engine are on outside. I want to place Content Engine Outside interface on PIX DMZ and then to run WCCP between Content Engine and Out...

Greetings,I am a total newbie to content networking (just a software engineer wearing too many hats), so please bear with me.I have a CSS 11000 SCA behind a 2950 switch / 2600 router and of the SSL certificate on the SCA needs to be replaced (it expi...

I have read the datasheet of WAE appliance. WAE deployment example, it works over WAN network.If I use WAE and then implement them over the Internet with IPSec VPN.Does it work over IPSec VPN over Internet?

Hi we got a MSFC and a CSM module on Cisco 6513 switch. Csm is in bridged mode. The problem is we can reach the servers behind CSM with no problem. But we can not ping any of the VLAN interfaces on the MSFC from the servers . What might be the proble...

I am facing a problem with Cisco Wide Area Application Engine ( Cisco WAE-511-k9). The connectivity is as follows:1.To the Serial Port(Back panel port 8 of WAE), i have connected my PC serial port. 2.To the Ethernet 1 port (Back panel port 4 of WAE),...

Hi there,I have a problem with the "inactiveTimeout" of tcp sessions.I have configured no special timeout for the owner "FARM" and content 7136.but some of the flows using this farm have an inactivity timeout of 608 sec.Especially all flows with "Flo...

Hi All,Was wondering if anyone has seen the following issue and found a cause. I can't see anything on Cisco regarding this.Issuing the 'script play showtech' command on an 11503 running 7.30.2.03 and saving the file to disk causes the CSS to crash.c...

I've installed a new CSM and I'm trying to monitor it by SNMP.Could anyone tell me which MIB must I monitor in addition to: 'slbVirtualServerState' & 'slbRealState' ?Thanks.Nereida

HiI want to loadbalance two asterisk boxes with a CSM-S. I'm using Direct Server return (no nat server), and it works fine for any tcp based service, but not for UDP, such as SIP or RTP. Can anybody help me? Is this kind of configuration not possible...

Hi, There: If I need to load balance some udp application with use udp port, could I just monitor keepalive udp port and with flow-state (port#) flow-enable?thx

Hi,I have a customer with a one arm setup. However they have no server vlan, only a client vlan. They are using source nat and it is working, however I am unsure how to setup redundancy as the alias command seems to be generally used on the server vl...

The site was unresponsive so I pressed post again... silly me...

Does anyone know how long is the wait time for the built in http get keepalive before it determines there's no answer and marks the service as dying? And is this configurable somewhere? I have an App owner who thinks the load balancer may not be wait...

Does anyone know how long is the wait time for the built in http get keepalive before it determines there's no answer and marks the service as dying? And is this configurable somewhere? I have an App owner who thinks the load balancer may not be wait...