Application Networking

Hi Experts! I am facing an issue while trying to capture a Span traffic on ACE  Tengig Interface .. Not sure what i am missing as  all the required configs seems to right... My ACE box is @ Slot 7 Router(config)#monitor session 1 source interface Te...

One of the feature of our application is that our Application Server initiate text message to our devices sourcing from UDP 1120 and device need to see the message come from a specific pubic IP (2.2.2.2) with UDP port 1120 and reply back with the sam...

                   Hi All,I have two N7k and I want to configure two VDC each VDC has different VTP and enable OSPF between the two VDCs by using four links my questions are:

All,I am planning to upgrade ten WAE 512 units from 4.4.5 to 4.4.7 and would like guidance from the forum here on how best to accomplish this.  I understand that the Central Manager can be used to mass deploy the software and upgrade the appliances a...

Hello all!I have simple serverfarm with one primary rsyslog and one backup-rsyslog configured. Failaction is configured to purge. When primary goes down all connections are correctly reset and newly pointed to standby unit (backup-rserver) which beco...

Hi all,If there is anyone out there thant can help me with this issue it would be greatly appreciated.One ACE Load balancer, balancing HTTPS traffic to a few servers.  Need to insert a x-forward-for on every packet.To my limited knowledge, this can b...

Hi,I have a demand for configuring serversida cookie sticky that includes a path, i.e:/path1/cookie1/path2/cookie2/path3/cookie3does it in the normal"sticky http-cookie cookie1 websticky1""cookie1" take the "/path1/cookie1" into account?Or in essence...

Hello Support Forum Members,i just create some ACL rules in cisco ACE 4710.here are some rules,class-map type http inspect match-any DENIED_URL  2 match url .*.exe  3 match url .*.php  4 match url .*.asp  5 match url .*.aspx  6 match url .*.cgi  7 ma...

I attempted to register a WAVE694-K-9 (running code 5.1.1.16) to our Central Manager (OE294 running code 4.4.5) but the registration failed due to a code mismatch between the two units.  The rest of the remote WAAS units (OE512's) are running 4.4.5 o...

Hi,So i'm looking at header-inserts on the ACE. We have a requirement to to instruct the ACE to redirect from HTTP to HTTPS should a HTTP request be made. This is fine and has been implemented, however, after the redirect we need to insert an header ...

Hi Allwhen i am trying to install Waas Network module NME-WAE-502-K9 at 2811 router i face a problem when trying to open a session on thr integrated service module as it takes too long time trying to open but no use as follows:Router#service-module i...