Application Networking

I am looking for a product that can load balance point-to-point or branch office IPSEC tunnels. The topology would be small IPSEC boxes at remote sites building tunnels to a central site with 5 or 6 larger IPSEC boxes. The tunnels from the remote sit...

Hi all,I understand this is a content networking furom. But I would like to ask some suggestions on our current deployment with CE507 using Secure Computing-SmartFilter as URL filter server.We have already already configured our CE507 and is already ...

Is there a general design rule for configuring source NATing ? Is it best to configure the CSS is one/two armed mode.What are the perfomance limitations in doing this ?Can soure NATed and non source NATed content rules be configured on the CSS with n...

Hi all!I'm having some real issues getting Passive FTP to work through my CSS - the setup is a fairly normal one: 2 VLANS (ext and internal); a content group with the application ftp setting and a group specifying the service to control NATing. Activ...

Hi everyone,I have a question about L3 sticky on CSS.I understand L3 sticky takes effect on the following situations,1: until expiring inactive timer2: until sticty table fulland 3: until the connection disconnect by receiving RST or FIN from client ...

CSS is disconnecting HOD clients. When HOD is pointed to the reals, the connections work fine. The disconnects do not happen all the time. I am wondering if the sticky is causing a problem with HOD disconnects. There is a correlation between using th...

We have numerous vservers supporting L4 load balancing - and have configured sticky based on source IP. We don't need stickieness across vservers - each vserver is independent and we just need to ensure that clients hitting a vserver will be directed...

HiIs the balance method "srcip" the same as the general method known as "sticky source ip"? Whereby, the same source ip will be directed to the same destination server by the CSS?Thanks in advance.

Hi,I am using the router mode load balancing. I checked the documentation and found that the VIP (virtual serer IP) is always the IP address on the Client vlan. The only time i saw the VIP on the server LAN is when we are using Direct Access.My quest...

This may seem a fundamentally basic question, but can the CSS11500 products load balance any kind of application on a group of servers? In otherwords none http/ssl based apps?If yes, are there any particularly problematic areas, maybe certain protoco...

If so what documentation is best for setting it up as I see only a linux boot screen and am not totally sure on how to configure/design. Thanks