Application Networking

I am led to believe that it's possible to load balance to different destination webs servers based on destination https:// adresses. I enclose my config which is not yet up and running as I am stuck at this point: I am using 2 11501’s without ssl mod...

Hi all,I had a strange problem with the redundancy between two of my CSS11000.They were both master at the same time. With resulted in total apocalypse 07:44:35 5/1 49369 IPV4-4: Duplicate IP address detected: xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx 07:44:...

i have recently been given the task to setup 2 11501's.i have put in the license key at the begining and configured an ip address. at this point i can not get past the offline dm and am lost as to how to get into the whole configuration section.i hav...

Hi,I just like to find out if the CSS11500 switches is capable of filtering the incoming URLs. The developers were worried that if someone typed in the URL of the full application interface or of a screen within the application they might be able to ...

I am working on a IP/TV solution integrated with ACNS. To the point, everything is setup and I am ready to stream. My problem arises when I try to take a .mpg or .mp4 and convert it to a hinted .mov file. When I use the IP/TV server application (vers...

Hi there, I have a cisco css-11506 running 7.50.1.03. One of our http content rules has 3 services using round robin and no sticky. Due to performance issues recently, 2 of the 3 servers had their tcp stacks tweaked to improve server to database comm...

Does anybody know why Cisco recommends using no Ip Proxy arp for the switch VLAN interfaces when using RHI on the CSM ?

Hello,I have two Cisco 7606 and I want to use them for load balancing with IOS SLB using the replicate casa.. The first has a MSFC SUP 720, while the seconf has MSFC/SUP 2.Is possible to have the replicate casa in this case?Thank youIra

http://www.cisco.com/en/US/products/hw/contnetw/ps2083/products_configuration_example09186a00801bbf4e.shtmlWe a have a configuration like in this link.But our vlan2 servers (ex.10.2.2.3) have some files or gadgets which run/get from servers in vlan1/...

hi~~~~ I am reading cisco document for VIP redundany VS Virtual interface redundancybut, i can't understand the difference VIP redundany and Virtual interface redundancy and shared vip redundancywhat is big difference for three funtion? i want easy e...

round robin is not working as expected - CSS11800 v6.1. service TEST-WB1 protocol tcp ip address 10.10.10.235 domain test.com no cache-bypass keepalive type tcp keepalive port 443 active service TEST-WB2 protocol tcp ip address 10.10.10.236 domain te...

Hi I am after a way to check the health of LDAP server, via keepalives. I know show you can check via the "port xx" command, but is there a scripted keepalive which would allow me to do this? Thanks in advance

Hi,can I use wccp redirect and PBR together? I tested it, but the redirection is not functional.:-( interface GigabitEthernet0/0 description DownStream ip address 172.24.0.1 255.255.0.0 ip policy route-map PBR-SLA ip wccp web-cache redirect in load-i...

I am going to be migrating from the F5 BIGIPs to Cisco's Content Switches. Are there any migration tools available or do I have to start from Scratch? Any input is greatly appreciated.