Application Networking

Is it recommended to use ASR on arrowpoint-cookie content rules? I know that when the primary css fails the backup css will accept cookies issued by the primary and then issue a new to the client one for the same server. I understand the need on st...

I’ve created two SMTP services and a content with this both 2. When I try to access the vip no problem but when I try to access directly the server (real ip of the server) through the CSS I arrive to an other SMTP sever.I use two CSS 11503 with versi...

I have come across a problem with a PalmOne Treo 650 Smartphone. This device uses Versamail which now has MS Activesync capabilities. This device is not able to connect via activesync over SSL. Although it will connect via activesync over port 80....

Hello Gilles, from you're previous posts I see that conns failures are caused by server sending RST packets or not responding to SYN. I have a situation where we have many real servers and everything appears to work fine, however in most cases I see ...

I am testing our new CSS 11501s (which are going to replace our old LocalDirectors), and have setup a little lab like so:Test PC|Router|| e5CSSe1 e2| |Srv1 Srv2I cannot seem to get the configured vip addreses to work, however I can connect to ...

Hi,New to this Forum, at least. Apologies if this is not appropriate for SLB questions...We have a standard IOS SLB setup with 2 x Cisco3725's running HSRP. IOS SLB setup for a few servers on private LAN. They're running www, ftp, https.We have a cus...

I trying to do AAA accounting for commands using a Content Engine CE-560 (ACNS 5.2.3 build b9) and Cisco Secure ACS (v3.1(1)build 27).I have de following configuration:tacacs key <encrypted>tacacs host 10.20.250.200tacacs host 10.10.250.200 primary!!...

Hey everyone.Does anyone have any experience working with the LDAP protocol and making policy decisions based on the content within LDAP queries?I was reviewing the CSM gear available to me and it would seem that I can do this for the HTTP protocol n...

Hey everyone. Can someone tell me what the proper image is for IOS on a 3845 so that I might do SLB? I loaded 12.4-1a (Advanced Enterprise) on my box and the gear isn't there (ip slb). I am starting to worry that possibly the ip slb stuff is only ...

Hi, I'm interested in what type of performance measurement MIB others are polling to determine the performance of their CSS? We have a basic CSS setup, sitting in front of multiple Web servers. Thanks

Has anybody tried using ospf advertise command to inject vip into ospf? I have tried this on both 7.4 and 7.5 with no success. The vip appears in the ospf lsdb on my CSS (not in IP routing table tho)but not in my 6500 lsdb directly connected on the v...

Hi,just two questions in regards of load balancing:1) Does the advanced-balance ssl notice if an sslid change is done in the SSL-Session (some clients reinitiate a session after some time)? 2) Is the sslid-stickiness aware of 1) and keeps the connect...

I have an Local Director 417 with one virtual ip and 4 servers served by the virtual ip. The LD 417 is currently operational.If I change the virtual ip using the command "ip address 10.10.10.3 255.255.255.0", will the command be effective right away ...