If a CSM has more than one client VLANs, connected to different routers, how does CSM decide what path to take when server initiate a connection? in other words is there a way to associate server vlan(s) to client vlan?
HiJust wondered if anybody has configured ACNS 5.1 with Smartfilter (also using NTLM authentication)?Usual story running out of time before an install and discover that the version of Smartfilter under ACNS 5.1 is different to 5.01, also looks like i...
Does anyone know if Cisco has a product or solution like the Radware Linkproof, F5 Link Controller, or WARP from Fatpipe that can provide Multihoming to more then one ISP without using BGP and also providing true load balancing which BGP can't do.
Hi Folks!I'd like to know if is it possible to forward MPLS and Multicast traffic through a CSM ?Gilles, Id like to see your comments about it.thanks in advance !Cristiano
I have a pair of 6513's with a CSM in each. These are port-channelled together to provide FT.I have a number of server vlan's defined on the 6500 and 2 of these need to be LB through the CSM.Do I define these servers as CSM server vlans (which I have...
I´ve been trying to run Load Balance on CSS11503 with an application which uses RPC UDP (port 111), but I haven´t found the correct configuration yet. I´m running 7.10 Build 305 version. I´m using the following:Service Server1 ip address 192.168.250...
May I come back to y.lo's message from January this year. He asked for a shutdown or halt command for CEs.There is a possibility to shutdown the NM-CE-BP (network module) with the service-module command form the IOS. There must be something similar i...
I am unable to browse to a virtual server from a real server. Any other computer on the network can browse to the virtual server. The LocalDirector and all real servers being balanced by it are plugged into a vlan that seperates them from the rest ...
Hi i have a question regarding advance balance arrowpoint cookie. The stickiness works fine unless the server goes down.When the server is dying and the user is making a request to the dying server then the CSS sends a RST but the client tries to rea...
I am trying to configure two CSM blade in two different 6509 chassis, my problem is when I configure alias on client side VLAN it start causing problem, and I see duplicate MAC address error in LOG. If someone has a sample configuration for this scen...
I just recently purchased two (2) CSS11501 for load balencing. I just took them out of the box and started to configure them, but I can't get past the offdm screen even after a reboot. Also, when I try to set my primary boot config, I only get opti...
In ACNS 5.X when you set up a hierarchical location tree, how does distribution allocation occur???By this i mean that if i have 3 location levels, level 1, level 2 and level 3, with 1 root CE in level 1, 4 CEs in level 2 400 CEs...
