Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The CSS11501 devices are not modular and thus don't support Gigabit interfaces (except for the uplink). We will have to upgrade those devices to CSS11503 with gigabit over copper modules correct?
Hi,I configured some thresholds on my HSE and sending e-mail for an alert (Administration -> Alert -> e-mail)The thresholds alert appear on "View -> Faults", but an e-mail is not send every time.Sometimes the mails are send, sometimes not. That´s str...
New to CSS 11506, trying to determine best method for fate sharing when using ASR. Have figured out VIP and Virtual Interface (I think, see below). But can't find any design info about whether to use ip critical-service (and how...) or ip critical-...
Trying to compare CSM and IOS SLB features. Read where the CSM can have "stateful" failover (maintains sessions) in a box-to-box scenerio. I also read where the IOS SLB can only provide "stateless" failover (I assume during failover, state/connectio...
Hi,I currently have installed smartfilter admin server on a WIN2K Server and accessed it from a win2k whith the smartfilter admin console.I would like to know what is needed to install, or activate the Smartfilter admin server on the CE-507. Regards...
A customer was asking whether or not they should use WCCP. First, I wanted to check to see how long Cisco plans to support it? Is it going away ant time soon?
We have an 11050 ver5.00 build 45 acting as the front end for 4 windows 2000 servers running Weblogic 5.1 SP13 for PeopleSoft tools 8.20.Our content rule has advanced-balance ssl and balance lconn configured. We are load testing the server using a pe...
Hi,does anyone know, how to interprete the timestamp of"Time last frame was seen = <time>"in "flow display <flows identifier>.This value seems to be an absolut timestamp, but I don´t know how could I find out the real time.In the example the value is...
Hi,We are running redundant CSS's in one armed mode, and we use the group command. We have one group of servers that has content from third parties (search Engines). Since putting the group command on (to correct one issue) the source address is now ...
Does anyone know if IOS SLB can function similar to Multinode Load Balancing (MNLB) in that the IOS router acts as a Services Manager which contacts the OS390 Worload Manager (WLM) who then reports back the best OS390 server for a particular connecti...
We currently have some servers that are being load serviced by an Alteon content switch. The rules were not written or are supported by our group. We have a printout of the config but it is a bear to translate. Are there any tools to translate the ...
Hello,we have a HSE 1.7.2, witch about 21 CSS Devíces discovered.After we did a upgrade by one CSS, it is not getting Discovered any more. It is alway listet in the undiscovered tab.What can i do, to troubleshoot this problem?Best Regards
Can anyone tell me what IP address health probes are sourced from on the CSM? I've got a simple ICMP health probe setup but I'm trying to figure out what the source of those probes will be. Is it the Vlan IP or maybe the VIP or possibily the router...
Can you have two stickys (one for generic and one for ssl) for the same virtual for 80 and 443 like this:virtual 192.168.45.1:80:0:tcp isvirtual 192.168.45.1:443:0:tcp isreal 192.168.45.10:80:0:tcp isreal 192.168.45.10:443:0:tcp isreal 192.168.45.11:...
