Application Networking

Hi,We are running redundant CSS's in one armed mode, and we use the group command. We have one group of servers that has content from third parties (search Engines). Since putting the group command on (to correct one issue) the source address is now ...

Does anyone know if IOS SLB can function similar to Multinode Load Balancing (MNLB) in that the IOS router acts as a Services Manager which contacts the OS390 Worload Manager (WLM) who then reports back the best OS390 server for a particular connecti...

We currently have some servers that are being load serviced by an Alteon content switch. The rules were not written or are supported by our group. We have a printout of the config but it is a bear to translate. Are there any tools to translate the co...

Hello,we have a HSE 1.7.2, witch about 21 CSS Devíces discovered.After we did a upgrade by one CSS, it is not getting Discovered any more. It is alway listet in the undiscovered tab.What can i do, to troubleshoot this problem?Best Regards

Can anyone tell me what IP address health probes are sourced from on the CSM? I've got a simple ICMP health probe setup but I'm trying to figure out what the source of those probes will be. Is it the Vlan IP or maybe the VIP or possibily the router i...

Can you have two stickys (one for generic and one for ssl) for the same virtual for 80 and 443 like this:virtual 192.168.45.1:80:0:tcp isvirtual 192.168.45.1:443:0:tcp isreal 192.168.45.10:80:0:tcp isreal 192.168.45.10:443:0:tcp isreal 192.168.45.11:...

Hello ... my question is similar to one posted recently. But I still cannot understand the reason.Our customer has a CSS x 2 with SCAs x 2 in a one-arm Proxy (transparent) operation.Currently we have 3 default routes as suggested in CCO.1 for upstrea...

Have anybody here had expirience with connectingCE5xx with URL filtering on Websensewith addition to AntiVirus filteringwith NAI MacAfee WebShield (e250 e500 or e1000) ?Witout using Webshield "on line" but like DMZ.For example like CE+Websens+Trendmi...

I'm looking the security Vulnerability for CSS. http://www.cisco.com/warp/public/707/cisco-sa-20040304-css.shtmlThe doc describes "vulnerability exists even when the Network Proximity feature is not configured".Do I need code upgrade even I don't hav...

Hi,I have a CE-560 running ACNS 5.1 with local websense integration. This is running without problems. I have a Trend Viruswall in front of this. Clients are set up with proxy pointing to Trend, which in turn points to CE-560 as proxy. CE-560 then do...

I am a little confused with Portmapping and the advice on Source Groups in the documentation.The section on "Configuring ASR" chapter 2 in the redundancy manual advises to Configure mutually exclusive port-map ranges on the redundant peers using the ...

Hi I am using CE 570.Now I have to use this command.But it does not support this command wccp spoof-client-ip enable.Here is some output of sh tech-support.opyright (c) 1986-2001 by Cisco Systems, Inc.Software Release: CE ver 2.51 (Build: FCS 05/24/0...

hello, I've setup a CSS115001 for load balancing two web servers. I am using just the basic L3 rule for load balancing and noticed that every so often I get this error:-"MAR 17 10:00:56 1/1 29 IPV4-4: Duplicate IP address detected for vip: 65.214.xx....