Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

HI,I have a strange problem. We have 6 WAAS Modules installed in C3945 Routers with the Enterprise License. The CCM ganz reach the modules do what the should do but after about 4 hours 2 of the modules stops forwarding the traffic they are not able t...

romueller by Beginner
  • 1199 Views
  • 1 replies
  • 0 Helpful votes

I have sticky group configured on my ACE30 with timeout value set to 65 sec.Could anyone explain me those big values (greater than 3900)  in time-to-expire column on some entries?Petrsticky group : ICMS-PL-STICKYtype         : HTTP-COOKIEtimeout     ...

p.hruby by Beginner
  • 1271 Views
  • 4 replies
  • 0 Helpful votes

Hi All, I had an issue with two ACE modules, working in active/standby mode. The active module was replaced after RMA and now I have active module with license ACE30-MOD-16-K9 and standby is with ACE30-MOD-08-K9. I have received the new ACE30-MOD-08-...

vaba by Beginner
  • 1405 Views
  • 3 replies
  • 0 Helpful votes

Hi all,  I am trying to turn up my new ACE30 modules. I have a 6506 VSS with sup2T 15.0(1)SY2. The new ACE30 came with 4.1, and the switch says:%C6KPWR-SW1-4-DISABLED: power to module in slot 2 set off (New fabric sync sequence not supported)OK. I ne...

jonagyula by Beginner
  • 789 Views
  • 2 replies
  • 0 Helpful votes

HiOne of my customers have a simple waas setup, One central manager (OI274) and one waas on the central site (OE674)(europe), two waas in China (OE574 and OE264)Now, the central OE674 stands as "offline" on the central manager.They are both on the sa...

pbuch by Beginner
  • 1294 Views
  • 4 replies
  • 0 Helpful votes

I have ACE30 in Cat6500 with several contexts configured.I'd like to restrict some user to be able to access only one context and he should be able enter show commands in this one specific context only.As soon as  I enable "changeto"  feature in Admi...

p.hruby by Beginner
  • 738 Views
  • 3 replies
  • 0 Helpful votes

HiI upgraded failover pair of ACE30 modules.There is this steps in UPGRADE GUIDE Step 8 Configure ACE-1 to autoboot from the latest ACE image. To set the boot variable and configuration register to1 (perform auto boot and use startup-config file), us...

We currently use 2 ACE 4710's in active standby mode in our DMZ to terminate all inbound SSL connections to backend web servers. To date this has worked well.The Ace's are in one arm mode hanging off one of our Firewall DMZ interfaces.I also use one ...

dclee by Beginner
  • 872 Views
  • 4 replies
  • 0 Helpful votes

Hi all, We are currently in the process of setting up a routed Mode context on an ACE4710 Appliance and have come across some problems which im hoping that someone here maybe able to highlight where we are going wrong.At the moment the setup is very ...

Wes Neary by Beginner
  • 1415 Views
  • 9 replies
  • 0 Helpful votes