Application Networking

We are just deploying CSS as a replacement to Local Director. A major problem we have concerns the ability of the servers behind the CSS to initiate sessions on their own for such things as dynamic page builds, SQL calls, or routine backup and maint...

I have a few client groups traffic-shaped on a router. The same router forward http packets with wccp2 to CE-550. I need to bypass specific http requests, for example, requests to ".zip" or ".mp3" urls (not only servers ip addressess). This packets m...

Is there a command to activate VLAN1? When I do "show circuit all" under circuit status it says "downipEnabled". How do I change down to active? The CSS is connected to 5509. I tried admin shutdown commands. The port on 5509 and e1 on CSS are 100-ful...

Encountering an issue with the CSS/SSL Accellerator - when a page is accessed through the ssl accellerator without a trailing "/" on directory entries, a page not found is being encountered instead of a lookup for a configured index page in that dire...

Hi, I'm looking for CSS11503 switch documentation (installation, different configuration types with scenarios and troubleshooting). I couldn't find the documentation on cisco's web site. All I got is product literature. I would appreciate if anybody ...

All our internet services like mail,SSL,FTP and http are hosted at one location.this will be our single point of failure, recently we had come up with DR site having all the services which are available on primary site. Using CSS11000 switch want to ...

As a followup to my last message, the config I'm using is as follows:ssl-proxy-list clear_ssl_list backend-server 1 backend-server 1 server-ip x.x.x.x backend-server 1 cipher rsa-with-rc4-128-md5 backend-server 1 ip address x.x.x.x active se...

Hello,I have a CSS 11500 and i have Linux-box witch Apache software is running.Whe are running on this box Reverse-proxy machine.And the IIS (web-server) is in the internal network.Can I monitor the Linux-proces with the CSS, and if the proces failed...

I have an 11506 connect between two 6500's. All the servers use the content switch as a gateway. I was trouble shooting a problem when I noticed that if I bypass the vip and hit a web server directly, the flow "show flows x.x.x.x" stays there for a...

When I configure sticky option on contents as follow content www vip address 172.16.1.1 add service web1 weight 2 add service web2 weight 3 add service web3 weight 4 balance weightedrr advanced-balance sticky-srcip sticky...

I am trying to setup VIP redudancy and would like to understand what circumstances cause a failover for the VIP. An example of what I would hope it does is if a redundant interface were to failover the VIP could be associated with it and failover as...

we are ISP and we have been using two cache engines in our NEtwork one is 570 and another is 550.But we are facing some problem since last month .The actual problem is it works fine and suddenly the browsing becomes very very slow for around 20 minut...

Hello, I am configuring the the above device, and would like to know how do I update the OS to 4.1 version and how to import the IIS 5.0 certificate and key into the Secure content accelerator config manager. I also need the 4.1 IOS to upload it to m...

Hi.I've defined a service as the type "ssl-accel-backend ". When I try to enter the "active" command to activate the service I get the error message "BAD IP ADDRESS".I've run out of things to check. Any clues??Cheers

I have 2 identcal web servers. I want everyone to ba able to access 1 web server ( which they can) and I want to specify only 1 network to be able to get to the other server (for testing rollouts , etc). Any good tips on how to get this done with a...