Application Networking

Hi,Branch router is connected to Central Office via IPsec tunnel, on LAN interface there is ip wccp 61 redirect in configured. Where should the ip wccp 62 redirect in be configured - on the physical WAN interface or on the tunnel interface or should ...

I have 3 virtual servers sharing the same IP, just using different ports.192.168.1.1:8000 = server1192.168.1.1:8001 = server2192.168.1.1:8002 = server3I would like to loadbalance across all 3 with the following probe, looking for the URL.http://192.1...

Hi,We have 4 GSS Boxes across the globe, Do we need to install the GEO DB License in all GSS boxes? Or only GSSM Primary is enough?And How about when we decommission GSSM primary and Bringup new GSSM Primary- We planned that for near future.Not sure ...

Hi AllCurrently we have the context name set up correctly but it inherits the admin's context sysname in our monitoring system.Is there a way to set up a host name for the context with out the admin context or is there any other way to do this? So wh...

How cisco ACE appliance changes its Ip address and MAC address after failover???

Hello,I am facing the follwoing problem,we have configured a cisco ace 4710 with VIP to load balance between two servers,this cisco ace is placed behind a cisco asa firewall ( with failover ) and the firewall is passthrough ( passing all traffic),whe...

Hello Everyone,I intend to Configure two ACE appliance in one arm mode, Post configuration I have tried to test the functionalities of the same.Below are the queries which I am having now.>Post reboot of the appliance it popped with the error ,pls cl...

                   Hi In my setup , I have 6500 with FWSM and ACE module . FWSM is configured in trasparent mode , multipl context . ACE is not yet configured .I have a requirement to configure the ACE to load balance exchage servers traffic.Exchange...

Hi Experts,My question is one of my ACE module running A2(1.6a) have been crashed due to SRAM parity error.ACE20Admin#show versionSoftware  Version A2(1.6a)last boot reason:  NP 1 Failed : SRAM Parity Error Chan 2I would like to know is this a Softwa...

Hi,Experiencing slow performance for http utilizing waas.When looking at the statistics, I see that some http request which is optimized/accelerated. Other is not. Those that has no optimization/accleration, the optimized traffic is higher than the o...