Application Networking

Ping to Gatekeeper from gateway is possible.A debug on cch323 ras, shows that it is timing out, or so it appears.---------------------x----------------------After readding the statements, Initially the gateway registers witht he gatekeeper, but aft...

1. What is the difference between FXO and E&M.2. Where I should use FXO and where I should use E&M.3. Why I should use only FXO and why not E&M??

The Cache Engines is caching for about 3-4 hours, and then it stops. Eventually, the cache is bypassed due to overload.This also happens everytime after the Cache Engine being reloaded.

what is the slot0: device on the MSFC used for? I can use the bootflash: device but there is no success operation with the slot0:

<pre>When I issue the following command on my Catalyst 5500 switch:sh cam dynamic 00-10-2f-f9-78-00I get this output:<ul>147 00-10-2f-f9-78-00 R 2/1-4 [ALL]145 00-10-2f-f9-78-00 R 16/64 [ALL]1 00-10-2f-f9-78-00 R ...

In order to provide voice quality for VoIP, is FR fragmentation equivalent to lowering the MTU size for the serial subinterface of a Frame relay subinterface? Is there any isues like stop communications, using Low MTU ?

is somewhere a list of multicast-mac addresses which are used on catalyst switches for different protocols (cdp,disl,vtp,uplink fast,dtp,bvst+)

I have had 2 separate VLANs. When one of the VLAN ports goes into errdisable mode, I have been able to clear the problem by enableing the affected ports.

Has anyone used the CSS to balance COM+ traffice? Developers have separated the COM+ from the IIS components for security reasons so the desire is have the IIS servers talk to a VIP representing multiple COM+ servers.Thanks,Brian D. Hamm

Hi, We have one CSS, the config are A/F : !Generated on 06/20/2002 18:40:21!Active version: ap0500002configure!*************************** GLOBAL *************************** acl enable ip route 0.0.0.0 0.0.0.0 192.192.51.250 1!*********************...

how would/can you configure a css device with a mirror/span-port? has the status changed during the last months? (see conversation a while ago). it should be used for attaching an ids device (or other sniffing services). i'm looking for a better solu...

We would like to load balance Linux FTP and Web servers with a CSS 11050 series device. Does the content switch use SNMP to load balance the servers? If so, which MIBs need to be loaded on the servers?

Is possible have two real IP bind to a virtual IP and after bind to another virtual IP the same real IP ??LOcalDirector 430

I have configured LD as follows:virtual 10.172.1.73:0:0:tcp is real 10.172.0.82:0:0:tcp is real 10.172.0.81:0:0:tcp is bind 10.172.1.73:0:0:tcp 10.172.0.82:0:0:tcp bind 10.172.1.73:0:0:tcp 10.172.0.81:0:0:tcp Will the LD load balance all the TCP traf...

does the local director work with random ports? could i use the local director to balance? if i have one tandem, and i use the port 23 (to Telnet) to the tandem.and the tandem answer with random ports.