Hi friends, I'm trying to configure the DNA with the Cisco 9300. Please do you have a guide on how to do it, as the configuration doesn't seem very user-friendly. I'll be waiting.
Forum Posts
I had a really old DNA sitting on a shelf since before COVID that i just plugged in.I got the CIMC setup and i ran the Maglev Wizard and i do believe it completed (finished after work hours).If i log into the CIMC and Launch the KVM is get a "Welcome...
all the vms on the esx restarted after deployed NDFC . it disables the access to the storage any idea ? ESXi vmware , the hardware is DELL MX 760
Good day,I am planning to get rid of the N5K Datacenter Fabricpath to be replaced with Nexus 9K.of course, VPC will be in place for the N9K but what will be the best replacement for the Fabricpath replacement.1- Migrating Cisco FabricPath Environment...
Hello Expert ,We are replacing the N3K device with N9K .We could see N3K has LAN_BASE_SERVICES_PKG license whereas in new N9K device there is no license ..Will this have any problem after the switch replacement ?N3K : N3K-C3048TP-1GE ...
Good afternoon,We need HTS, Harmonization Code and ECCN for the following item.Cisco Catalyst 3560-CX 12 Port
Consider that L3Out Link is not yet in Place between PRD Tnt to ISN RTR ( at left side of the Diagram ). I am evaluating the situation if I bring the L3Out Link between DR PRD Tenant to ISN RTR. At DR Site PRD Tnt through L3Out it will receive Route ...
Hello WAAS Experts,Can Cisco WAAS communicate with Juniper WAN Optimizer? If so, which Cisco and Juniper hardware models?Thank You,Audie
Good DayI have a pair of C8200L devices racked and online.These will be running a redundant Call Manager Express install.First I am told I must configure Box-to-Box redundancy.I navigate here but find this document unusable:Home > Support > Product ...
I'm looking for the HTS and ECCN for an XRV-M7-APLN-100G.
Recently, while downgrading the APIC, the equipment seemed to freeze, so I performed a reboot. However, the boot process does not proceed beyond the screen shown in the attachment. The same issue occurs when attempting to boot using USB, vCIMC DVD, ...
Hi Team, It is possible to use Cisco SNS-3715-K9 (ISE) and SNS-3615-K9 (ISE) together in a high availability (HA) configuration. Regards, Anand Gupta
Dear all,may I ask you a support for missing HTS code for the following item?Part number: SMC AMC520-N04BDescription: EXHAUST CLEANER INSURE CLEAN PLANT AIR AND REDUCE NOISE POLLUTION OVER 35DBThanks in advance.Best regards,Paul
I'm trying to run a tcl script (via automation or pasting into vty. The commands all individually work but if I try to push it all out, it stops feeding the commands after the first "if" conditional command.I'm basically trying to rewrite a couple o...
