You entered mmod in 9.3(9).During interface shutdown, the equipment was stuttering and the interface status was input/adminCfg/down/up, etc., and the direct -> success took about 3 minutes to complete shutdown.Is there anyone who has experienced the ...
Anyone else having issues installing this COP file? I see it listed a requirement in the upgrade guide and TAC confirms I should install this file before Fresh Install with Data import to version 15 . The cop file will install on some nodes and not ...
I have the problem too, and don’t found a solution for that issue It happens on Cisco 9300 switch,the version of the Cisco switch is 17.12.3
This is not a minor severity. It makes the cli almost unusable.
Hi! I have been encountered the following message "Potential CSRF attack detected". I've tried to reconfigure the SAML within the ASA, but It doesn't help. I'm using the AnyConnect software and everything seems to be working fine when I'm authenticat...
Please clarify the requirements to mitigate the Vulnerability.3.3.0.430-Patch6 is enough to mitigate the Vulnerability or required ise-apply-CSCwo99449_3.3.0.430_patch4-SPA.tar.gz even if ISE is work in 3.3.0.430-Patch6.
I have a IP desk phone ( Yealink MP54 ), it works correctly on Catalyst 3650 and C9300L, but on Catalyst C9300LM-48UX-4Y running IOS-XE 17.09.04 or 17.12.04, I need the workaround "power inline port 1-event" on the interface !Is this a bug on the C93...
After install 802.1x I have the error's as:Feb 9 07:47:19.951 CET: %SYS-5-CONFIG_P: Configured programmatically by process EPM IAL Process from console as consoleFeb 9 07:47:19.954 CET: %SYS-5-CONFIG_P: Configured programmatically by process EPM IAL ...
I have the same Problem my IOS version is: show versionCisco IOS XE Software, Version 17.09.05a Jun 23 13:17:20.889: %IOSXE-3-PLATFORM: R0/0: kernel: igb 0000:23:00.2 fpe2: PCIe link lost, device now detachedJun 23 13:17:20.890: %IOSXE-3-PLATFORM: R0...
Hi, I ran into this issue with a fresh installation of CUCM version 15SU2.
Hello ppl,any ideas on QR (Quishing) protection with ESA SEGs topic?Looks like that even with Image-Analysis feature, SEGs are not able to scan (suspicious) URLs encoded as QRs in message embedded pictures.There is a feature request [CSCvs55128] sinc...
Cisco CBR8, connected to 3.0 Cable Modem, the board will restart from time to time, how to solve itJun 7 17:35:07.170 beijing: %USJIB-3-NON_CRIT_INTR: C1/0: cdman: US-JIB device Non-Critical [J4US Interrupt Received: [GLOBAL][HiPri]:Partial Reset Sta...
Could somebody show me a short config for b), how to create a "dummy" VFI with all vlans? b) Else, if (a) doesn't work, configure a new "dummy" VFI, allow all the vlans. At this point CPU should subside, and the the new "dummy" VFI can be deleted. ?
As it can be read by the title, I'm experiencing some problems with the platform in the "5.3.1.7 Check Your Understanding - Basic Network Devices" exercise. It gives wrong corrected answers and it's not the first time it happens in the whole course.H...
