03-25-2022 01:17 AM
I have two DNA Cetners and on one when I create a discovery I have the option to select the Netconf port but on the other is says "No credentials to display".
Even on the one where it is there I cannot find where I configured it.
Anyone know where I can configure it?
Both running 2.2.3.4
Solved! Go to Solution.
03-25-2022 04:13 AM
Hello @pinglis
You can add the NETCONF credentials directly from the Discovery page. There is a button to do so, and then a pop-up will appear and you'll be able to configure the NETCONF parameters.
Regards,
Sylvain.
03-25-2022 04:13 AM
Hello @pinglis
You can add the NETCONF credentials directly from the Discovery page. There is a button to do so, and then a pop-up will appear and you'll be able to configure the NETCONF parameters.
Regards,
Sylvain.
03-25-2022 04:23 AM
Many thanks!
03-25-2022 04:25 AM
Hope below URL help you :
03-25-2022 06:24 AM
DNAC will use the same CLI credentials it uses to discovery the device in order to SSH on the netconf port (830 by default) to the device for validation.
03-25-2022 06:31 AM
The netconf port to use is not defined by the default and you need to define it before you can enable netconf in a discovery.
Sylvain_Che answered the question of where to configure it.
03-25-2022 06:42 AM
That's correct. However, it is defined & configured as port 830 by default on the network device side.
10-17-2022 08:04 AM
DNAC Suggestion: would be cool just to configure this under Design > Network Settings > Device Credentials.
we will have to most likely enable netconf soon to do wireless at our FIAB sites since it appears at these sites we have to enable the wireless controller on the 9300 series switches we have at those sites.
-Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide