DNAC Will Not Provision Template For Catalyst 9400

[zachartl]

Hello,

I can't seem to provision a Configuration Template for a Catalyst 9400 switch. The same Template works fine on a Catalyst 9300 Switch. I did add the Class of switches - 9400 Series Switches within the Template Editor Configuration. Committed the changes as required but when I go to Inventory -> Provision -> Provision Device 

The 9400s show up as "Devices Having No Templates" 

The 9400 switch version is 17.9.1 

Our DNAC version is 2.2.3.6

Again, this template worked like a champ on the 9300s Same Location. 

Thank you,

Terry

[Preston Chilcote]

I think you have enough information to open a TAC case.  Include for them the exact model of 9400 ("show inventory")

[rasmus.elmholt · Accepted solution]

Have you added the 9400 in the network profile for the template as well?

[zachartl]

Indeed, please see enclosed. Thank you for asking though. And my apologies for the late response.

[rasmus.elmholt]

Is it added in the network profile as well?

[zachartl]

It was not. Great Call, Thank You!

Have a great weekend.