03-21-2024 01:39 PM
While provision a switch to the fabric site I came across this issue of the provision conflict. Although the provision template is the same used by the other switches but they had no issue.
Attached is the error which pops up in the DNAC.
In order to fix this issue I deprovisioned the switch, resynched it but still it shows the same issue. Is it some sort of a bug ?
Thank you.
03-21-2024 02:16 PM
Look for the failed Provision task in Activities->Task (from main menu) and click "See Details". Keep drilling down on the Failed stages until you get the specifics of the failure. Most often it's related to one of the commands in the template and this procedure will show you exactly which command the network device complained about.
03-25-2024 11:49 AM
The switch do get provisioned successfully
once I change the focus to the template its shows that there is a conflict.
and then i view configuration for this particular switch it highlights following lines.
vtp mode transparent
vtp domain xyz.ad
The are many devices which are running with the same template and they didn't encounter any issue. Is there a way to fix this issue?
03-25-2024 12:21 PM
"and then i view configuration for this particular switch it highlights following lines."
A screen capture of this page you mentioned would be helpful
03-25-2024 12:56 PM
Below is the config for that switch:
03-25-2024 01:39 PM
Does it give a hint if you hover over the warning sign on line 44?
03-26-2024 06:20 AM
Yes, it does say Conflicts with Intent.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide