Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking for a scenario where i have a switch C9300 running C9800 wlc , and i want to connect ap 9124axd as a root ap and then link (Backhaul) it to the another ap acting as a mesh ap.I know it is doable , i am looking for some helpful document...
Below are the steps which I followed to create this SNMPv3 RO:1. Create a group.2. Assign a security level to the group3. Create a user4. Assign this user to the group 5. Set password and encryption level----------------------------------------------...
While provision a switch to the fabric site I came across this issue of the provision conflict. Although the provision template is the same used by the other switches but they had no issue.Attached is the error which pops up in the DNAC. In order to...
Under the Cisco DNAC in the Fabric Sites i am see the following error(alert ) message: There are configuration updates available for this SD-Access fabric site: 1 Critical Fix(es). Critical fixes should be applied as soon as possible. Click here for...
Migrating the switch in IDF to SDA , I have a question related to the AP connection to the Embedded WC at the BN.It has always been a problem to see the AP's back in the DNAC. Before that the AP's are connected to the standalone WLC 5500. My question...
The Cisco CC version which i am running is 2.3.7.10 which supports RAP/MAP ap. The problem arises when i change the ap from local mode to bridge mode it does shows up in the Not Joined AP list on the C9300 Web GUI. I see following error on the switch...
