Does anyone know if there is still a limitation on the number of nodes a call can flow through before it is disconnected/timed out?I know back in version 8.0/8.5 this limit was set to 999. As I understand it, this limit is now configurable, but is t...
Forum Posts
Upgrading 6000 from 7.1(4) to 7.3(0). Guide says you must first upgrade to 7.2(1)N1(1) and then to 7.3(0)N1(1). But 7.2(1)N1(1) guide shows supported paths from 7.1(1)N1(1)—7.1(3)N1(2) to 7.2(1)N1(1). Can you upgrade from 7.1(4)N1(1) to 7.2(1)N1(1...
My company has a Cisco ASR 1001 Router that is sending netflow data to a cisco prime infrastructure installation and to a riverbed steelcentral collector (appresponse). There exists a rather large discrepancy between what the two platforms show as fa...
I want to test ikev2 on gns3 , kindly provide the way and what exact image can i use to do it .I tried using many images and it says not supported . I read I can use c7200 image but I cant seem to find the image needed. can someone advise plz ( oly ....
I have multiple Catalyst 4500s running cat4500e-universalk9.SPA.03.11.00.E.152-7.E.bin The recommended versions are either 16.6 or 16.9 That seems like a huge jump...... What is the difference in these releases? Is it a license/feature connected ...
Resolved! Packet Tracer problem
hello guys, as the title says, im currently having a problem with a simulation in packet tracer; i basically created 3 networks, each with two hosts and connected to a switch, the main goal is to be able to send PDU's across routers through static ro...
sorry problem solved...please just delete this thread. thank you
Experts, I am currently trying to list all 802.x interfaces which have more than 3 mac addresses learned - by using cisco prime compliance jobs, when I want to issue below command by choosing the "Device Command Outputs", it seems <1.1> is not workin...
I got this error already converted to smart entitlements when putting the pin for getting the license please help me on this
Hi, did someone know in which version of ios could be used command virtual-service. I have ova file for Openflow plug-in but without this command i couldn't activate this plug-in.
Hi all, I got an AIR-CAP3702I-E-K9 access point and I would like to know if it's possible to make it work standalone as I don't have wireless controller. Is there any way I can get software? Thanks
Hello,I would like to know the maximum speed supported by the routers cisco series 800. BR,
My office is now working from home. We have the Cisco SPA504G phones. In the office they usually ring all together, with one phone being the "main" phone.Now we are working remotely with one person in the office, the phone in the office rings and on...
I have opened the history database file, but no messages were saved at all, only contacts and participants - is there any way of accessing the last even 20 messages? I have version 11.7. Thanks.
Recently we have installed an ISR4431, with the firmware version 16.10.1a. We would like to use traditional licensing method to install PAK in the router, as the place where the router installed may not have the access to the cisco smart license port...
