Hi Folks,Labbed it quickly & i wondered if it's possible to set interfaces to no passive-interface vlan51 for example and then do a default passive-interface. I found that I couldn't do this without effectively configuring default passive-interface a...
Forum Posts
Is it standard practice to design networks that include reliance on STP for redundancy? I've recently inherited a network with a sizeable amount of loops and discovered STP blocking at least one interface on each switch I come across. The networks I ...
Is there a way to restore Cisco 300-24UX DNA Subscription License ? I made a mistake of running the "license smart reservation request all" on a stack of 4 C9300s. Currently, one is in "Reservation in Progress" while another is "Not Installed". I s...
This is a bit of a weird situation. I use the Jabber desktop app on my PC for use alongside a virtual desktop (Citrix). Every so often (maybe once every 10 days of using), when Jabber rings, it freezes my monitors completely and they shut down. Nothi...
Each time i try to ping cisco.srv, i get this response "Ping request could not find host cisco.srv. Please check the name and try again."
Cisco Unity 14.0.1. Changed to 365 oath 2, set up app registration, service account, all necessary settings about 15 months ago. Everything working until 5 days ago. The errors many have dealt with are now effecting my set up and driving me mad: Conn...
I'm curious to know if anyone has experience with this new N9k model? It supports 1000/100/10 Mbits which would be useful in our OOB estate and is cheaper than it's higher throughput cousins.The minimum nxos version is v10.4 though, which makes me he...
Recently picked up a Nexus 93180yc-ex from eBay and the seller did not properly wipe the switch before shipping. Switch is in ACI mode and doesn’t seem to want to enter the boot load mode. I’ve tried CTRL+C, CTRL+[, Break key, special command for bre...
Hi everyone,this will be a long post so thank you in advance to who will read it.I'm trying to set up a CISCO C9800 Controller deployed on Microsoft Azure in site-to-site configuration.To this end, I'm following this guide: https://www.youtube.com/wa...
Hello, Do you guys know if Cisco catalyst 1300 integrates with Cisco ISE?I need to know before buying it...I need to integrate it in my client's infrastructure. Can anyone help me with this info if it's available? Thank you
Hi all,I don’t even know if this is the right subreddit to post this in, but I’m hoping to get some help with Webex.My organization hosts webinars for a few hundred people a couple of times a month. In these webinars, we often share PowerPoint slides...
I think I can work this out by logic, but I'm not a net-eng, so a little unsure of my rationale, would love someone else to either tell me my thinking is correct, or tell it's not and why. Much appreciated.I was wodnering if isolated ports can talk t...
We'd like to nat the source private IP from our AWS end over IPSec VPN tunnel on another end, which is Cisco CSR 1000v router, here is the diagram. IPSec VPN is configured with route-based via tunnel interface with AWS end, we'd like to nat 10.251.15...
Updated an SG350-52P to the latest firmware, and it's working fine, I am able to log in, but it no longer appears in the FindIT utility. Is there something new to the firmware that makes it disappear, is there a setting to make it discoverable?
Supposed I have a stack with several hundred PCs, APs, cameras and IP Phones attached. I only want to add a single command to the PC ports (all of which have the exact same config).Is there a way to do this that doesn't involve a bunch of repetitive ...
