This document covers the procedure for configuring Speed-dial and Abbreviated dial setup. This procedure is applicable to Cisco Unified Communications Manager Version 7.x / 8.x / 9.x
Configuring Speed-Dial Buttons or Abbreviated Dialing
You use Cisco Unified Communications Manager Administration to configure speed-dial buttons for phones if you want to provide speed-dial buttons for users or if you are configuring phones that do not have a specific user who is assigned to them. Users use Cisco Unified CM User Options to change the speed-dial buttons on their phones.
From CUCM 8.x onwards, system provides a total of 199 speed-dial and abbreviated-dial settings.
Speed Dial Settings
Configure these settings for the physical buttons on the phone.
Abbreviated Dial Settings
Configure these settings for the speed-dial numbers that you access with abbreviated dialing. When the user configures up to 199 speed-dial entries, part of the speed-dial entries can get assigned to the speed-dial buttons on the IP phone; the remaining speed-dial entries get used for abbreviated dialing. When a user starts dialing digits, the AbbrDial softkey displays on the phone, and the user can access any speed-dial entry by entering the appropriate index (code) for abbreviated dialing.
Note: Not all Cisco Unified IP Phones support abbreviated dialing. See the phone user guide for information
Perform the following procedure to configure Speed-Dial.
This procedure is applicable to Cisco Unified Communications Manager Version 7.x / 8.x / 9.x
Greetings everyone, what is the best method to move from CUCM v8.6 which is hosted on MSC to CUCM v11.5 which is hosted on vmware ESXI USC. I tried using Recovery and Restore and got an error while restoring it to v11.5.Tried export and im...
Hello TeamPlease I need your help. About 2 months now, incoming calls no longer reach the IP phones on configured extension. Outgoing calls work perfect. And internal communication works fine. Line can be heard ringing from caller side but does not ring o...
Dear All, we want to use cisco 2901 voice bundle router as a gateway for freepbx IP PBX. after creating SIP trunk between them, outgoing calls working but we're having issues on incoming calls are not reachable on freepbx extensions. after debugging ...
Serial0/1/0:15 AirtelSerial0/1/1:15 TataAirtel DID 46809100 till 46809300Tata DID 68339100 till 68339299We are using 2 different SP PRI on our VGW....facing issue with the Caller ID ..below is the DID no. details & Port on VGW where PRI connected &...
Hello all ,I am beginner for the world of telepresence , my customer request to me do a model of deployment cisco metting server , but the problem the cms need a licence for function , can i get a licence demo for this deployment ? how ? and where ? ...