ACE Replacement

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-18-2013
08:49 AM
- last edited on
03-25-2019
07:23 PM
by
ciscomoderator
With ACE being phased out, will there be a change in CVP support for third-party load balancers such as F5 and Citrix? Or will CSS be the only supported platform?
- Labels:
-
Other Contact Center

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-18-2013 01:27 PM
Andy, how timely. I was searching around with the same question and found this.
http://www.citrix.com/products/netscaler-application-delivery-controller/how-it-helps/cisco.html
I haven't read all the links in it but I'm suspecting that this may answer our question(s). I also hear a rumor that it's on CCW for direct quote/purchase but I haven't gotten that far into the mess.
Any other input from anyone?
/Jeff
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2013 10:01 AM
BU is evaluating F5 for laod balacing and planning to certify it for interoperability by September this year.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2013 03:21 PM
Will there be similar configuration guidance for the netscaler/F5 load balancer to interoperate with CVP as there is in the "CVP Configuration and Administration Guide" for ACE?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2013 07:35 PM
F5 /Netscaler are 3rd party vendors, the configuration used for these components during the interoperability test with CVP will be captured in the interop doc for guidance and will be published. Please note that there are different options available to configure these load balancer for expected behaviour, customers should refer documentation and seek support directly from the vendor, if required.
