PG Configuration

[cristian.gomes]

We have just installed an UCCE lab with the following topology:

  1  Progger(PG,Router+Logger),
  1 IPIVR
  1 CM Cluster (PUb and Sub).

  Since it is for lab purpose, I have only one PG point to Pub CTI Manager.

I was asked to use the same pim pointing to pub & sub. I noticed that if I configure both Ip addresses
(Picture_1) PIM Proccess start normally. So, my question is:

  Can I use it as a valid configuration or  creating another pim on the same PG point to the sub would be a valid option?

  I would appreciate receiving an clarification on that, since  documentation is not so clear.

Thank you in advance

[Chris Deren · Accepted solution]

No, if you do that your CUCMs will esentailly be seperate clusters and device association would need to be seperate. I have seen deployments where the PIM points to 2 hostnames/IP addresses seperated with comma,  but that is not supported. For lab purposes you could try it.

HTH,

Chris

[cristian.gomes]

Chris,

Thank you very much.