06-01-2014 09:12 PM - edited 03-14-2019 01:29 PM
Hi,
I have problem when i want upgrade patch my uccx from 8.5 to 8.5 su4.
The upgrade is success but there are many service that won't start, some stuck in starting state and some stopped (commanded out of service).
06-03-2014 07:37 AM
Hi Riza,
Are the services enabled from the GUI interface of UCCX are you able to enable them and start them from either the GUI or CLI? Where they running prior to the switch version to su4?
Hope this helps
Tony
Please rate helpful posts
06-03-2014 07:35 PM
Hi Tony,
Unfotunately i can't access the gui, because Tomcat service wont start, i have tried stop and start service by CLI but it still stuck.
Thanks,
Riza
03-29-2016 12:05 PM
Hi Riza
have did you fix your problem ? i had same issue like yours .
uccx 10.6 pub and sub
install the cert for pub and sub . after that reboot pub working fine and sub tomcat cannot start .
try to reboot couple times and still same issue
any help please .
08-22-2016 10:25 AM
Were you able to find the solution.. I am also facing the same issue.
Found existing defect :
CSCtq46632
Workaround:
CLI "set cert regen tomcat" not correctly regenerating the tomcat.keystore file
restart the server after executing the above command. it worked for me.
08-22-2016 10:25 AM
What all services are not coming up.Single server or HA, post the output of below commands from the server(s)
show version active
show version inactive
utils service list
utils core active list
file view install system-history.log
Regards
Deepak
08-22-2016 10:49 AM
Hi Deepak,
Tomcat service was the issue. Found existing defect(CSCtq46632) . Workaround given in the defect solved my issue.
01-25-2018 12:23 AM
Watched Tomcat STARTING for 30 minutes, using utils service list cmd.
Patch upgrading from 8.5(1)S2 to SU4.
Then Googled the symptoms and came across this posting.
It's a single UCCX server, self-signed certs.
Ran 'set cert regen tomcat' and the did a utils system restart.
Services came back and was able to finally log into the UCCX gui!
thank-you. Wasted about 40 minutes of my time and it's way past midnight but would have taken longer if not for this posting.
06-05-2014 05:02 AM
Hi Riza,
Have you uploaded custom certs for tomcat? If not, then please try the following command:
set cert regen tomcat
Restart the Cisco tomcat after this.
What about the restart of the Server? Also is this a single node or HA?
Regards,
Arundeep
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide