cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

1682
Views
0
Helpful
7
Replies
Highlighted
Beginner

Wrap up code not popup during call transfer

Hi

We have a Cisco UCCE Setup version 7.x. As per the client requirement we have to enable the Wrap up Code pop up when the Agent transfer the call to another CTI Route Point. However it is not popping up, only it comes up when the call is disconnected. I would really appreciate if I can get a help how to configure it.

Regards,

Rohit

7 REPLIES 7

Wrap up code not popup during call transfer

Dear Rohit,

When you transfer a call from CTI Toolkit, you will not get any wrap up data, since ICM will treat this call as an outbound call.

As per the AgentDeskSetting we dont have any option for wrap up like 'Required with wrap up data' for work mode on outgoing.

Choosing wrap up code for call disconnection available if we disconnect inbound call.

We have option known 'Required with wrapup data' for work mode on incoming.

So by default we cannot provide the wrap up data for transfer and out going calls.

But we can set wrap up timing from Agent desk setting.

Hope above will serve your purpose.

Regards,

Shalid K.C

Beginner

Hi ShalidI've tried the

Hi Shalid

I've tried the workaorund you provided but it is not working for me. I am transferring the call by single step method and after that i am not getting any wrapup window but have to make agent ready manually.
 

Regards,

Muhammad Ahmad

Dear Muhammad,  Could you

Dear Muhammad, 

 

Could you please share screenshot of your agentdesk setting. also let me know are you using CAD or CTIOS tool kit. 

 

Regards,

Shalid

Beginner

Dear ShalidWe are using CTIOS

Dear Shalid

We are using CTIOS toolkit for agents. Please find attached screenshot.

Dear Muhammad, change the

Dear Muhammad,

 

change the workmode on incoming as required with wrapup code and outbound as required. 

you dont need to make agent ready manually since the Cisco will make agent back to ready after confiured 10 sec of wrap up time. let me see if i can test in my lab. i also update you if find anything .. Please update me your result. 

 

 

Beginner

Hi Shalidno luck :(i was

Hi Shalid
no luck :(
i was using customized CTIOS. Will check on standard CTIOS and update you.

Beginner

Re: Wrap up code not popup during call transfer

Hi Shalid,

Thanks alot for ur help, really appreciate it...

Regards,
Rohit

Sent from Cisco Technical Support iPhone App

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here