port-channel

[kdaramola]

I have port channel created on a vss upstream switches with 2 ports bundled together  and I have port_profile created on 1000v  with channel group configured on port profile but won't come up.

sample config

port-profile type ethernet vm-traffic-uplink

  vmware port-group

  switchport mode access

  switchport access vlan 130

  channel-group auto mode passive

  no shutdown

  system vlan 120

  state enabled

[Robert Burns]

Why do you have access vlan 130 but "system vlan 120"? Also can you try mode active?

[lwatta]

Your port-profile config needs to mirror how the port-channel on the VSS is configured. So if it's a trunk on the VSS then it needs to be a trunk on the Nexus1000V. If its an access port on the VSS than make it an access port on the port-profile as well with the same vlan numbers.

Also what version of Nexus 1000V are you using? If you are using 1.4 I would recommend turning on LACP offload.

louis

[ike1]

This is a sample of the configs of the configs on a por-tcahnnel  config going to 2 NICcards on a server

interface Gigabit Etherneth 7/10

description server

switchport

swichport access vlan 10

switchport mode access

no logging event link-status

load-interval 30

speed 1000

no snmp trap link-status

channel-group 20 mode on