3800 ISR integration with Bogen T100 paging

[balitewiczp]

Looking for any info on integration between a 3800 ISR and a bogen overhead paging amplifer/system.  I would assume the standard vwic2-fxs card would be sufficient, but I have read that there is an extended loop (vic2-2fxs-e/did)  version with higher ringing current  of this and wonder if it would be beneficial to get this card.

any help is appreciated.

thanks

[Chris Deren]

I am not familiar with T100, is this a paging adapter or paging amplifier, zone controller?

With paging adapter, i.e. TAMB2 you  can use either FXO (trunk) or FXS (station) connection and both work very well.

Chris

[Brandon Svec]

Yes, use Bogen TAMB between FXS and T100.  FXO can work too, but then you need to add -24V power supply for TAMB.  With FXS power supply is not needed.

[balitewiczp]

Thanks, all, for the responses.  I am told now that i am connecting to a Bogen C60B amplifier.  Im assuming a fxs to a Bogen TAMB is still the way to go?

[balitewiczp]

just an FYI, I got this working with FX0--->Bogen UTI1 Adapter-----> Bogen C60B

Thanks for  all the suggestions