cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1999
Views
0
Helpful
2
Replies
Highlighted
Beginner

7914 Expansion Module Issue

We have several 7914 Expansion Modules registered on our network, approx 30 or so. I haven't had any trouble up until a recent site install. I cannot seem to get the units to come up, at all. I was trying to add about 10 of them, 5 of them worked and 5 did not. There doesn't seem to be any rhyme or reason to why certain ones work and others do not. I've got them working on both 7961 and 7965 models. I've got them working at different site locations. The ones that are not working, will not work anywhere. I've switched phone button templates several times, i've switched cables, i've reset phones, i have about 100 free licenses on my cucm. I've done just about everything i can think of besides a firmware upgrade which i don't think will help because we have units running the same firmware as the units that are not functioning and they are having no problems. Not sure where to go from here. We are running CUCM 6.1, firmware load is 8-3-3. Under settings>status>expansion module on the phone menu, it shows neither module configured. Any help would be greatly appreciated.

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Beginner

Re: 7914 Expansion Module Issue

I had a similiar issue with expansion modules on 6.1 .Try reseting the TFTP server.Also 8-3-3 is very buggy code , i would suggest a change to 8-4-1

mark

2 REPLIES 2
Beginner

Re: 7914 Expansion Module Issue

I had a similiar issue with expansion modules on 6.1 .Try reseting the TFTP server.Also 8-3-3 is very buggy code , i would suggest a change to 8-4-1

mark

Beginner

Re: 7914 Expansion Module Issue

Resetting the TFTP services on both publisher and subscriber seemed to resolve the issue.

Thx

Rich

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards