09-26-2012 09:46 AM - edited 03-16-2019 01:24 PM
Hi
Need some help.... I've enabled the Headset Hookswitch Control on CUCM for a cisco ip phone 7945. it says it is enabled and it successfully reboots the phone. But when I check the phone Device Configuration - Media Configuarion it shows disabled. Trying to setup a plantronics cs350 witn a cisco ip 7945.
tx
09-26-2012 10:07 AM
Are you asking about "Wireless Headset Hookswitch Control"?
When you say "Device configuration - media configuration" what page are you exactly referring to?
Chris
09-26-2012 11:30 AM
Hi Kynan,
So, from CUCM admin Device>Phone you set the Wireless Headset Hookswitch
Control >Enabled>Save>Apply
Then when you check via the phone it still shows disabled?
If so, can you please provide the CUCM and 7945 Firmware versions
Cheers!
Rob
"Why not help one another on the way" - Bob Marley
07-26-2013 01:07 PM
I am having the exact same issue. Never saw an answer for this.
Fimware version:
SCCP45.9-2-3s
System version: 8.6.2.22900-9
Ideas?
11-18-2013 08:59 AM
I too am having the same issue.
System version: 9.1.2.10000-28
SCCP45.9-2-1S
11-18-2013 09:20 AM
Hi there,
Did you check out this bug that seems to apply to 7945's with
the firmware you are running;
Reset of phone makes the plantronics headset not to work
Cheers!
Rob
"Why do the best things always disappear "
- The Band
11-18-2013 09:29 AM
The issue we are having is that even though you set the phone for
11-18-2013 09:35 AM
OK. I fixed it.
1. Set the phone for
2. Factory Reset the phone
When the phone came back from factory reset it now shows under Device Configuration>Media configuration>Headset Hookswitch Control- Enabled
So looks like a Factory Reset does the trick.
04-02-2014 07:36 AM
Thanks a lot for this trick!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide