07-20-2011 08:34 AM - edited 03-16-2019 06:02 AM
I have an 8961 phone that I am trying to register with our CME 8.6 with no luck. It looks like the 8961 is supported using SIP firmware but when I enter the load 8961 command under telephony services I am not able to define the firmware. Can't figure out what I am missing. Any help would be greatly appreciated.
OS Description | Cisco Internetwork Operating System |
---|---|
| Cisco IOS (tm) C2800NM |
Cisco IOS Software | C2800NM-IPVOICEK9-M |
Software Version | 15.1(4)M / CME 8.6 |
Feature Package | IP|VOICE|SSH|3DE |
GUI Version | 8.0.0.0 (Compatible with IOS 15.0(1)XA) |
Thanks
Jess
07-20-2011 09:54 AM
Hi there,
If you're configuring a SIP phone, you'll need to use 'voice register global' instead of telephony-service. See below:
R3-CME(config)#voice register global
R3-CME(config-register-global)#load ?
3911 Select the firmware load file for 3911
3951 Select the firmware load file for 3951
7905 Select the firmware load file for 7905
7906 Select the firmware load file for TNP 7906 phone
7911 Select the firmware load file for TNP 7911 phone
7912 Select the firmware load file for 7912
7941 Select the firmware load file for TNP 7941 phones
7941GE Select the firmware load file for TNP 7941GE phones
7942 Select the firmware load file for TNP 7942 phones
7945 Select the firmware load file for TNP 7945 phones
7960-7940 Select the firmware load file for Telecaster 7960 & 7940 phones
7961 Select the firmware load file for TNP 7961 phones
7961GE Select the firmware load file for TNP 7961GE phones
7962 Select the firmware load file for TNP 7962 phones
7965 Select the firmware load file for TNP 7965 phones
7970 Select the firmware load file for TNP 7970 phones
7971 Select the firmware load file for TNP 7971 phones
7975 Select the firmware load file for TNP 7975 phones
8961 Select the firmware load file for RT 8961 phones
9951 Select the firmware load file for RT 9951 phones
9971 Select the firmware load file for RT 9971 phones
ATA Select the firmware load file for ATA
HTH,
Chris
Please rate helpful posts
07-20-2011 11:52 AM
Thanks Chris. I had to also enter in mode cme, after the voice register global command, but then I was able to specify a firmware load. Thanks for your help!
07-20-2011 11:57 AM
Great, glad I could help, thanks for the rating!
Chris
Sent from Cisco Technical Support iPhone App
01-05-2012 02:40 PM
Has anyone seen a config guide or sample config for 8961 on CME 8.6?
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide