01-16-2015 01:35 AM - edited 03-17-2019 01:36 AM
I have just connected a 2nd wic card in our 2821 for an additional 5 isdn 30 channels. I have gone through the config in the router and I am trying to work out the commands required to use the additional lines.
Solved! Go to Solution.
01-16-2015 03:41 AM
Hi,
In addition to what is said by AOK[+5], you need to configure
a. card type e1 0 0 [check the slot]
b. framing under controller E1 0/0/0[check in your case]
c. pri-group timeslots 1-31
d. no shutdown
regds,
aman
01-16-2015 04:27 AM
And probably network-clock-participate & network-clock-select commands too.
The exact details will vary depending on the gateway protocol you're using (MGCP, H323, SIP, etc)
GTG
01-16-2015 03:03 AM
That depends on what type of vwic card it is. If its a mft-e1-t1 card, you will need to first of all specify the card type before you can even begin to configure it
01-16-2015 03:41 AM
Hi,
In addition to what is said by AOK[+5], you need to configure
a. card type e1 0 0 [check the slot]
b. framing under controller E1 0/0/0[check in your case]
c. pri-group timeslots 1-31
d. no shutdown
regds,
aman
01-16-2015 04:27 AM
And probably network-clock-participate & network-clock-select commands too.
The exact details will vary depending on the gateway protocol you're using (MGCP, H323, SIP, etc)
GTG
01-16-2015 04:28 AM
c. pri-group timeslots 1-31
Ooh, watch out. The original poster said they wanted to use 5 channels...
GTG
01-16-2015 04:30 AM
my mistake..
thanks for correcting me.
regds,
aman
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: