adding, resetting a sip trunk

[iptuser55]

I would like to add a new sip trunk - "test" to an existing SIP GW for testing. The GW already has some production SIP Trunks connected but I need to create a new one to testing some settings which would involve resetting it

The existing SIP trunks are already in their own RL, RG and so this new one would be in a dedicated RL,RG by itself with dedicated Route points relating to it

Question If I reset the "test" sip trunk which is on it`s own  RL,RG which Ive just created, would it reset the production ones since they all point to the new same GW?  or be ok ?

thanks

[Ayodeji Okanlawon]

First of all, to add a new sip trunk to an existing gateway (already using sip trunk) you will either need to use a different port number for SIP or use a different IP address on the gateway.

Secondly, No it will not reset the existing sip trunk. They are different from the application point

[iptuser55]

Thanks, Can the port be any number bearing in mind any firewall issues? ?- Any special configuration on the GW if I use a different port other then 5060?

[Deepak Mehta]

I would say use next 5061 as non secure as this is commonly used and i have one set up in my lab .

[gauravpurohit]

5060- unsecure; 5061- with TLS is the default.

Generally you wouldn't steer away from standards.

As per Deepak's comment, CUCM will then use 5061 to CUBE/GW. In order to achieve similar behaviour from CUBE to CUCM, I believe on dial-peers pointing to CUCM you define port 5061 along with IP address & change SIP trunk security profile to accept messages on 5061.