Apply SIP profile to SIP phone dial-peer

[nmdc.kzstan]

Hi,

CME  creates dial-peers for SIP phones:

HUB#sh dial-peer voice summary 
40001  voip  up   up             140$               0  syst ipv4:192.168.120.22:
40002  voip  up   up             180$               0  syst ipv4:192.168.120.21:
 

Is it possible to apply SIP profiles to theses dial-peers? I would like to modify 

SIP messages sent from CME to phones.

TIA

[Aaron Harrison]

What modifications would you like to make?

[nmdc.kzstan]

I enabled remote-party-id under sip-ua to display Called Name instead of Called Number  on calling phone (SIP phone to SIP phone).  But after enabling when calling PSTN numbers from SIP phone over SIP trunk  PSTN number is not displayed on calling phone. I think that is because remote-party-id and description before From in SIP message sent to phone is empty so one way of solving it is to add description to SIP message header.