06-11-2007 10:40 AM - edited 03-14-2019 09:59 PM
the ata is connected to a CME. the analog phone connected to this ata does recieve calls, but it can't make calls (no dial tones..).
Do i need to work on the ATA configuration or the CME? and how?
06-12-2007 12:41 AM
Hi
You have to register the ATA (if it's not auto reg)then assign it, css, part, dir number
/ama
06-12-2007 03:12 AM
Which image are you using on the ATA ?
06-12-2007 04:30 AM
what do u mean by image?
Let's tell u what i did:
I did all the configuration needed for an ATA in the IP-PBX (Cisco 2821).
It seems that the ATA and the CME are talking. When i make a call from any IP phone to the ATA, it works-you hear the analog phone ringing, but i'm not able to make a call from the analog phone that is connected to the ATA.. Any help?
03-21-2010 11:05 AM
Is your Cisco ATA 186
running SIP or SCCP firmware?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide